Flipsky DIY Electric Skateboard Controller 4.12 50A Based on VESC 4.12

Pay with

About Flipsky DIY Electric Skateboard Controller 4.12 50A

Specs: ◆ Hardware:V4.12 ◆ Firmware: V3.40(Keep upgrated with the latest firmware version) ◆ PCB:4 layers, size: 40*60mm ◆ Current: 50A continuous / 240A peak ◆ Voltage: 8V-60V (Cells: 3-13S LiPo) ◆ Recommended 10S battery ◆ BEC: [email protected] ◆ BEC type: Internal driver support ◆ Timing: Software calibration ◆ Motor control interface: PPM signal (RC servo), analog, UART, I2C, USB or CAN‐bus ◆ Cutoff Voltage: Programmable ◆ Frequency: PWM input ◆ Governor: No ◆ Weight: 80g ◆ FSESC4.12 Size: 60x40x20mm ◆ Programming card: No ◆ Reverse: Yes The shipping package contains: 1*FSECS4.12 1*Mini USB 1*VESC Sensor Wire 1*Manual Features: ◆ STM32F4 32Bit ARM micro-controller. ◆ DRV8302 MOSFET driver / buck converter / current shunt amplifier. ◆ 6pcs IRFS7530 MOSFETs. ◆ Regenerative braking. ◆ DC motors are also supported. ◆ Sensored or sensorless operation. ◆ Adaptive PWM frequency to get as good ADC measurements as possible. ◆ Good startup torque in both sensored and sensorless mode. ◆ Duty‐cycle control, speed control or current control. ◆ Wireless WII nunchuk (Nyko Kama) control through the I2C port. This is convenient for electric skateboards. ◆ Optional PPM signal output. e.g. when controlling an RC car from a Rasp Berry Pi or an android device. ◆ The USB port uses the modem profile, so an Android device can be connected to the ESC without rooting. Because of the servo output, the odometry and the extra ADC inputs(that can be used for sensors), this is perfect for modifying an RC car to be controlled from Android (or Raspberry Pi). ◆ Sensored and sensorless (FOC) Field Oriented Control allows your electric skateboard to run with barely any motor noise, it auto-detects motor parameter since FW3.34.