ERYONE 3D Printer Photopolymer Resin Super Low Odor, General LCD UV-Curing Resin 405nm for LCD 3D Printing 500G Transparent

Pay with

About ERYONE 3D Printer Photopolymer Resin Super Low

Advantages: 1.Super low odor less irritant, less corrosive. 2.Super low odor less irritant, less corrosive. 3.Compatible with LCD DLP 3D printers 4.Suitable for school, hobby etc. Resin Parameters: Capacity:500g Exposure parameters: Bottom exposure time(s) 20-100s, 60s, normal exposure time(s) 2-8s. Viscosity (25 ℃):150-250 mpa.s Liquid density:1.05-1.25 g / cm3 Solid density: 1.05-1.25 g / cm3 Flexural Modulus: 59-70Mpa Tensile Strength: 30-52mpa Shore Hardness: 82-88D Solidify wavelength:405nm Penetration Depth:0.124mm Critical Exposure Value:0.7mj/cm2 Notched IZOD:44-49J/m Elongation at Break:11% Precautions: USE personal protection equipment (PPE): 1.Wear appropriate chemical-resistant gloves (nitrile or neoprene) – DO NOT use latex gloves. 2.Use safety glasses/goggles with UV protection. 3.Wear a dust mask when sanding or post-finishing parts. First aid procedures: Flush contaminated eyes or skin thoroughly with plenty of water for 15 minutes. Wash skin with soap and plenty of water or waterless cleaner if needed. If skin irritation or rash occurs, seek qualified medical attention. If ingested, do not induce vomiting. Seek medical attention immediately. Store correctly: 1.Keep resins sealed tightly in their containers, out of direct sunlight and within the temperature range of 20°C - 25°C. 2.A small headspace of air is needed to keep the resin from gelling. Do not fill resin containers to the top of the opening. 3.Do not pour used, uncured resin back into new resin bottles. 4.Do not store uncured resin in refrigerators used for food and beverage storage.