AlphaTrak 2 Control Solution Package of 2 Bottles

Pay with

About AlphaTrak 2 Control Solution Package Of 2 Bottles

AlphaTRAK 2 Glucose Control Solution is used to perform quality control testing on the AlphaTRAK Blood Glucose Monitoring System. It allows you to make sure that your system is working correctly and it helps to verify that blood glucose (sugar) readings are accurate and reliable. What is the AlphaTRAK 2 Control Solution? AlphaTRAK 2 Control Solution contains a fixed amount of glucose. It is used in conjunction with the AlphaTRAK Glucose Monitoring Kit including glucometer and test strips. Control solution helps ensure that your glucose meter is working properly so that each test result is accurate and dependable. Each package contains 2 bottles (4 ml) of control solution. Formulated for: Dogs and cats. Not for human use. How does this product work? Control solution tests should be performed under the following circumstances: when you first get the meter, before doing a blood test, when you begin using a new vial of test strips, if you have forgotten to close the test strip vial, when you suspect that the meter or test strips are not working properly, when the blood glucose test results are not consistent with how the animal is acting, or when you think the results are not accurate. A control test should also be run If you drop the meter or upon the advice of a veterinarian. For detailed instructions on how to run a control test, refer to your user manual. A control test is run using the same procedures as with a drop of blood. Insert a test strip into the meter and make sure your meter is set up and ready to use(see user manual). Shake well and gently invert the control solution bottle. Wipe the tip with tissue and discard the first two drops. Apply and hold control solution to 1 sample area of the test strip until you see short lines moving clockwise on the display or until you hear a beep. This indicates the test strip obtained enough control solution and the meter is processing. If the test does not start after applying the control solution, go to