All Categories
Set of 12 Heat Exchanger Bands for standard 6 inch diameter stove pipe. (Approximately 19 inch circumference)
Wrap-around / Snap-On...Install in less than 5 minutes. No need to remove the pipe.
Reclaim wasted heat going out the stack
Stove Pipe heat exchangers release free heat into your room
Made in the USA
Description 6 inch dia. (19" cir) stovepipe heat exchangers, set of twelve snap-on bands. stovepipe reclaimer / radiator rings that extract heat from the hot stove They make close contact with your stove pipe and extract more usable heat from the hot pipe.. Just like the aluminum fins on a motorcycle engine, they increase the surface area of hot, exposed metal and allow more heat to be radiated and released. Made of 28 gauge high thermal conductivity aluminum. Attach quickly and easily to your stovepipe, no screws or tools are needed. The ends lock into each other, taking about 10 minutes to attach all 12 radiators. The bands conduct heat from the points of contact on the stovepipe to the loops in the band where the heat is released into the room. Each radiator has 10 loops that are 2 inch x 1.5 inch…that is 30 square inches of sheet metal in each band. 12 bands gives the equivalent of 360 square inches of sheet metal. This creates the equivalent of a 18 inch x 20 inch sheet of hot sheet metal, 500 - 700 degrees, radiating heat from both sides of the sheet into the room before it escapes out the chimney. That is like a small space heater itself. And it is FREE HEAT. See my other listing for 3, 3.6, 4,5,6,7,and 8 inch diameter. They will last a lifetime and may be re-used if you replace the stovepipe. They never need maintenance. Put on as many bands as you wish. This set of 12 will cover a 18 inch length of pipe. . NOTE: The length of stovepipe in the picture is not part of the sale.