We specialize in hard to find items
All Categories
Aluminum 5052-H32 Continuous Hinge without holes, Unfinished, 0.04" Leaf Thickness, 1-1/2" Open Width, 5/64" Pin Diameter, 1/2" Knuckle Length, 6' Long (Pack of 1)
Share Tweet
of brand new stock?
or
Need this item ASAP?
Check if this is available on Amazon
or available in other sites
Send us the link so we can buy for you
Aluminum 5052-H32 Continuous Hinge without Features
-
Surface-mounted for applications requiring continuous support along the full length of the hinge, such as hollow metal doors and frames, and for use with wood and aluminum
-
Aluminum 5052 is weldable, stronger than aluminum 3003, and more corrosion resistant than steel and aluminum 3003
-
No holes allow hinge to be spot welded in place or drilled for use with screws and rivets
-
Unfinished for projects with less exposure to corrosive environments
About Aluminum 5052-H32 Continuous Hinge Without
The aluminum 5052 continuous hinge has no holes and is suitable for surface-mounted applications requiring uninterrupted support along the full length of the pieces being joined. This hinge is suitable for hollow metal doors and frames, and for use with wood and aluminum. Aluminum 5052 is weldable, stronger than aluminum 3003, and more corrosion resistant than steel and aluminum 3003. However, aluminum 5052 does not provide the same strength as steel and stainless steel. This hinge can be customized for various surface-mounting needs because it does not have pre-drilled holes; it must be spot welded in place, or drilled for use with screws and rivets. Since the hinge is unfinished, it is suited for applications that will not be exposed to corrosive environments. The range of motion for this hinge is 270 degrees from the folded position. Continuous hinges, also called piano hinges, provide support to run the full length of the doors, panels, or pieces being joined together. They are manufactured in a variety of materials and sizes, with or without holes, finished or unfinished, and can be cut to specific sizes. They also vary by knuckle length, pin diameter, leaf thickness, and open width. The knuckle is the tubular part of the hinge through which the pin passes, and knuckle length is the measurement of an individual section. The pin runs the length of the hinge holding the leaves together. The leaf is the flat metal portion of the hinge that extends laterally from the knuckle and revolves around the pin. Open width is the dimension from the outer edge of one leaf to the outer edge of the other when the hinge is fully open.
