X

Solar Street Light,150W Motion Sensor Solar Light LED Flood Light All-in-one Design Solar Wall Light Lighting Waterproof for Garden, Outdoor, Yard,Pathway, Basketball Court,Garage (150 LED with Pole

Product ID : 41726457


Galleon Product ID 41726457
Model
Manufacturer
Shipping Dimension Unknown Dimensions
I think this is wrong?
-
Restricted product. We cannot ship these kind of products

Pay with

About Solar Street Light,150W Motion Sensor Solar Light

INTRODUCTION ; The solar wall light can automatically detect surrounding brightness and human activities: it enters charging mode to convert sunlight to electricity that is stored in the built-in battery in daytime; it automatically lights up at night when the high-tech built-in sensor detect human activities. For energy saving, it will enter sleeping mode in 20 seconds when the human activities was not detected. NOTICE; You can use the always-on mode, it can working if not with motion sensor also, the solar light will always be on . MOTION SENSOR SOLAR LIGHT Product Manual Solar panel: 9V7W Battery: Lithium battery 3.7V 12000mAh Current: 2A Power: 15W ,Output power ;150W LED quantity: 150 pcs (2835C 22-24lm 6000K-6500K) Max lumen: 2500lm Response angle: >180° Response distance: 5-10m( 33ft ) OPERATION GUIDE The default mode of the product is OFF mode. Turn on the switch when using the product. PACKINGLIST: 435*235*90mm , Weight: 2.5Kg It is recommender to turn off the light and charge it under direct sunlight for 6H before the first use. Make sure the product has enough power. 1. Solar Wall Light3. Wall mounting screw. 5. Screw nut 2. Mounting Bracket4. Bracket screw 6. Screw bolt 7. User Manual OPERATION GUIDE The default mode of the product is OFF mode. Turn on the switch when using the product. EASY TO INSTALL; All-in-one design, the front is the LED light, the back is the solar panel ,with bracket screw fittings, etc, Punch two holes on the wall with a drill bit and insert the attached wall plugs into the holes. Then, twist the screws through the screw holes of holder into the wall plugs. Adjust the angle, and then tighten the holster and the light through the knob screw.