X

XADO Revitalizant EX120 Metal Conditioner for Steering Wheel Power Booster and Hydraulic Equipment Oil Additive - Protecting Fluid from Wear (Syringe, 8 ml)

Product ID : 4950110


Galleon Product ID 4950110
Model
Manufacturer
Shipping Dimension Unknown Dimensions
I think this is wrong?
-
1,916

*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown

Pay with

About XADO Revitalizant EX120 Metal Conditioner For

The product is designed to protect against wear, restore and repair a power steering booster and other hydraulic equipment. Due to its by 20% greater* active agent’s concentration, it offers strong restoration potential to the worn out surfaces and wear protection. During treatment of the hydraulic units the product forms a protective metal-ceramic coating on the surfaces of the titling and actuating mechanisms and switchgears (valve spindles). As a result, the operation characteristics of the hydraulic equipment are restored. *Compared to XADO gel-revitalizant for Power Steering Pumps No matter how well a power steering system is maintained, high heat and friction causes metal to become worn, scratched, and deformed over time. The destruction of the surface layer occurs in high-friction areas, where entire groups of atoms – clusters - may tear off under extreme loads. Until now there was no way to reverse this inevitable metal wear. APPLICATION: Treatment of a unit with 1 -2 L hydraulic system capacity Introduce (spray) the contents of a tube (can)* in the fluid, which is warmed up to the operating temperature, in the tank of a power steering pump After the revitalizant is applied and the engine is turned on, wait 2-3 minutes and turn the steering wheel for 5 minutes Revitalization is considered complete after the mechanism has been in operation for 50 hours ( 950 miles of run) * It is recommended preliminary to dissolve the contents of the can (tube) in small amount (~ 50 ml) of used hydraulic fluid. If the fluid in the tank of a power steering pump is contaminated (opaque or has change its initial color etc.), it is recommended to change hydraulic fluid before application. DOSAGE: Oil System Capacity, L to Number of syringes (8ml), pcs needed: 1-2L = 1 Syringe 2-5L = 2 Syringes 5-8L = 3 Syringes *1GAL = 3.785L 1QT = 0.946L 1PTS = 0.47L