X
Lubegard 19001 Kooler Kleen Transmission Cooler
Lubegard 19001 Kooler Kleen Transmission Cooler
Lubegard 19001 Kooler Kleen Transmission Cooler
Lubegard 19001 Kooler Kleen Transmission Cooler
Lubegard 19001 Kooler Kleen Transmission Cooler

Lubegard 19001 Kooler Kleen Transmission Cooler Flush, 13.25 oz.

Product ID : 6997735
4.6 out of 5 stars


Galleon Product ID 6997735
UPC / ISBN 083137190011
Shipping Weight 1.2 lbs
I think this is wrong?
Model 19001
Manufacturer Lubegard
Shipping Dimension 9.49 x 2.76 x 2.76 inches
I think this is wrong?
-
1,655

*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
  • Electrical items MAY be 110 volts.
  • 7 Day Return Policy
  • All products are genuine and original
  • Cash On Delivery/Cash Upon Pickup Available

Pay with

Lubegard 19001 Kooler Kleen Transmission Cooler Features

  • Will not leave behind water or soapy residue to contaminate the transmission

  • Removes grease, dirt, sludge, grime and metal shavings

  • Will not harm seals or degrade new automatic transmission fluid

  • Kooler Kleen is re-packaged for auto makers

  • Special Shipping Information: This item cannot be returned and has additional shipping restrictions


About Lubegard 19001 Kooler Kleen Transmission Cooler

Description Dr. Tranny Kooler Kleen Flush Cleaner with Universal Tip is used, repackaged and designated by multiple car manufacturers and the largest transmission rebuilders. This is because it is the only mineral based transmission line flush. There is absolutely no water used in the formulation. Caustic water-based flushes leave behind a film of detergents and dispersants, water and soapy residue that will become part of the new ATF when the transmission is re-installed which can cause shudder and damage to clutch plates. Lubegard Kooler Kleen ensures the new ATF stays free of water and that the transmission is installed to last. Lubegard Kooler Kleen is a three-in-one product. Transmission rebuilders use it as a line flush cleaner, a wire harness cleaner, and a dielectric protectant. For use as a line flush cleaner: simply attach the connector to the transmission feed line; next, attach the hose to a transmission return line to collect flush and residue in a waste container; hold the can upright and actuate; flush until clear. For best results use the entire content of can per installation. Then turn the can upside down and continue cleaning with air only. For wire harness cleaner: cut off the hose to appropriate length to direct the stream. Spray over dirty depowered 6-12 volt electrical components. For a dielectric protectant: allow cleaned components to dry before repowering.