CNC Spindle Motor Kit, MYSWEETY 110V 2.2KW Water Cooled Spindle Motor + 2.2KW Single to 3 Phase VDF+110v Water Pump + 3.15 Inch Clamp + 196 Inch Water Pipe + 40 Inch Electric Wire+ 13pcs ER20 Collet

Pay with

About CNC Spindle Motor Kit, MYSWEETY 110V 2.2KW Water

1.Spindle Motor: Size: 80mm Power: 2200W Voltage: 110V Frequency: 0-400Hz Speed: 0-24000rpm Water Cooling ER20 collet Runout off: less than 0.001mm Germany SKS 4pcs bearing Bearing type: 2 x 7005C P4 DT & 2 x 7002C P4 DT Grease Lubrication Power Interface: Optional GX16 waterproof air plug, there are marked 1234, 123 were connected to the inverter power supply (U, V, W), 4 connected inverter ground 2.Inverter: Type: 2.2KW/110V Input: 110VAC/50Hz Output: 0-220VAC 3-phase Frequency: 0-400Hz Size: 168x124x161mm 3.ER20 Collet Set: Gripping Range: 1MM to 13MM (1mm, 2mm, 3.175mm, 4mm, 5mm, 6mm, 7mm, 8mm, 9mm, 10mm, 11mm, 12.7mm, 13mm) Run-out tolerance 0.01mm (0.0006") 4.Water Pump: Voltage: 110V Structure: Single-stage Pump Pressure: High Pressure Application: Submersible Usage: Water 5.5M Water Pipes: Length: 5M Can be connected between Water Pump and Spindle Motor 6.Spindle Motor Clamp Mount: Diameter: 80mm Material: Aluminum,Surface sandblasted Application: Wood working industry rourter, such as wood door milling engraving and cutting, furniture producing Package include: 1 x 110V 2.2KW Spindle Motor 1 x 110V 2.2KW VFD 1 x 110V 75W Water Pump 1 x 5M Water Pipes 1 x 80mm Spindle Clamp (Free 3pcs screws) 13 x ER20 Collet (1mm, 2mm, 3.175mm, 4mm, 5mm, 6mm, 7mm, 8mm, 9mm, 10mm, 11mm, 12.7mm, 13mm) 1 x 70mm Brush 10 x Drill Bits How to connect: The package come with two Aviation plugs, just put the little one into the spindle, then use the large one to fix into the little one, you will see the marked number (1.2.3.4) on the top of large one, Pin 1 goes to terminal U on the vfd. Pin 2 goes to terminal V on the vfd. Pin 3 goes to terminal W on the vfd. Pin 4 is a ground/common.