JIFETOR Engine Oil Pressure Gauge Transmission Fluid Diagnostic Tester Tool Kit 12PCS, 500psi Automatic Gearbox Pressure Meter with Hose and Adapters

Pay with

About JIFETOR Engine Oil Pressure Gauge Transmission

PACKING LIST 1x 3-1/2" Pressure Gauge with 40" Long Hose and 1/8" NPT Brass Adapter 1x 3/8" NPT Male x 1/8" NPT Female Brass Adapter 1x 1/8" NPT Female x 1/8" NPT Female Brass Adapter 1x 1/4" NPT Male x 1/8" NPT Female Brass Adapter 1x 1/8" NPT Male x 1/8" NPT Male Brass Extension Adapter 1x 1/4" NPT Male x 1/8" NPT Male Brass Adapter 2x 1/8" NPT Male x 1/8" NPT Female Brass Adapter(90 Degree Elbow) 2x 1/8" NPT Male x 1/8" NPT Female Brass Adapter 2x 1/16" NPT Male x 1/8" NPT Female Brass Adapter 1x Customized Blow Molding Case, 12-3/4"L x 10"W x 2-1/2"H 1x Instruction EASY TO OPERATE 1. Remove low oil pressure switch 2. Attach tester using appropriate adapter(s) for the engine 3. Start engine 4. Read the pressure on the gauge 5. Verify vehicle oil pressure is normal against manufacturer's recommendations 6. Remove tester and turn off the engine 7. Replace the low oil pressure switch DIAGNOSTIC RESULT Please refer to equipment manufacturer's operation instruction and compare to the manufacturer's recommended readings, to check if the reading is out of the normal range. And check if the dashboard light works well or not Below the minimum oil pressure: blocking oil strainer or oil filter, broken pressure-limiting valve spring , poorly working oil pump, low oil viscosity Above the maximum oil pressure: high oil viscosity, blocking lubrication oil channel, blocking oil filter core and by-pass valve is difficult to open NOTE 1. Please wear gloves and goggles when use 2. Test oil pressure by professionals or under the guidance of a professionals 3. You can use Teflon tape to wrap around thread connector to get better sealing