KUNHEWUHUA 20X30cm Resin Stamp Making DIY Photopolymer Plate 2pcs Craft Letterpress Polymer Solid Photopolymer Plate for Printing Yellow

Pay with

About KUNHEWUHUA 20X30cm Resin Stamp Making DIY

Product discription: Solid resin polymer plate is a kind of polymer photosensitive material. It can be widely adapted to the printing of trademarks, books, newspapers and social prints. The solid photosensitive resin plate manufactured by our factory adopts high-quality imported raw material synthetic coatings and the product quality exceeds the quality standards of similar products. DIY Stamp Making Instruction: 1. Print the image that you want to use to create your photopolymer plate on a transparency sheet using an inkjet printer. Cut a piece of photopolymer plate 1/4 inch wider and taller than the design on the transparency sheet, using the metal shears. Trim the transparency to the same size as the plate. 2. Cut the two pieces of clear acrylic the same size as the plate, using the metal shears. Remove the protective film from the surface of the plate that will be exposed. Position the plate on one piece of acrylic. Place the transparency on the surface of the photopolymer plate with the ink side down. Place the second piece of acrylic on top of the transparency. 3. Place the clamps on each of the four sides of the acrylic, plate and transparency, to hold them together. Place the entire assembly under an ultraviolet lamp. Set a timer for 1 minute. 4. Turn on the lamp and activate the timer. Turn the ultraviolet lamp off when the timer reaches the set time. Remove the exposed plate and remove the clamps from it. 5. Place the exposed plate under 4 or 5 cups of clean water in a large plastic bowl. Brush away the soft unexposed photopolymer from the surface of the plate using a soft nail brush. Hold the plate under water and use a firm circular scrubbing motion. 6. Dry the plate using a hair dryer on low heat. Set the timer for 1 minute, and place the dry plate under the ultraviolet lamp for a final hardening. Turn off the lamp and remove the plate. Handling time: 3-5 days It will be delivered within 3-5 days