Hitaco 3M VHB Double Sided Tape Acrylic Foam Tape, Heavy Duty, Industrial Mounting Waterproof, LED Strip Lights, Car Decor, Home Decor and Office Décor, 33 Feet x 0.4 Inch, (Double Sided Tape 5925)

Pay with

About Hitaco 3M VHB Double Sided Tape Acrylic Foam

Double Sided Tape 5925 is a 0.025 in (0.64 mm) thick black double coated acrylic foam tape with PE film liner. The modified acrylic adhesive on both sides bonds to a broad range of high, medium and medium/low surface energy substrates including metals, glass and a wide variety of plastics and paints, including many powder coated paints. The very conformable foam provides good contact between substrates even when they are slightly mismatched. Our brand tape offered by Hitaco as a perfect companion to our many LED strip lights. Get the right tape the first time to finish all your fix-its at home or at the office. Specifications: ✔ Black Double Sided Tape. Length 33 feet; Width 0.4 inches; Thickness: 0.025 inches. Application Guide: - Surface Cleaning: Quick pre-clean of tough spots if necessary. Wet cloth to remove most contaminants. Final wipe with dry cloth. - Priming the Surface: Primer on a disposable towel, followed by a dry towel. Dauber bottle followed by a dry towel. Foam brush. - Abrading Your Substrate: Light abrasion by hand. Clean the substrate after abrading to make sure all sanding debris is removed from the bond area. - Tape Application by Hand: Start the tape at the edge of the surface and lay it down, applying constant pressure as you go. Apply a roll down force of at least 15 lbs with a dense J-roller over the entire area to ensure good contact between the tape and the first substrate surface. Remove the protective liner to apply the other substrate. - Applying Final Pressure: Applying pressure to the applied tape facilitates optimal wet-out onto the substrate. Bond strengths at the minimum application temperature will be achieved as follows: 20 minutes 50%, 1 hour 75%, 24 hours 90%, 3 days 100%. Assemblies can be handled within 10 minutes but bonds should not be stressed before 72 hours.