12 volts lead acid battery DESULFATOR Assembly DIY

Pay with

About 12 Volts Lead Acid Battery DESULFATOR Assembly DIY

this is a 12 volts lead acid battery desulfator Reconditioning a Lead Acid Battery Desulfation (also know as Reconditioning or electrolyte stratification) offers a way to be brought back to life and for tired batteries to be rejuvenated. Desulfation will not bring batteries with a shorted cell, or worn out plates back to their former glory, but it is a valuable tool for anyone depending on battery storage for power who cannot afford to buy new batteries. - the process can takes up to 2 weeks INPUT VOLTAGE 12Vdc ( NOT INCLUDED) OUTPUT VOLTAGE 20-30V (pk-pk) RATED CURRENT 100-150mA Average @ nominal 12Vdc input. FREQUENCY RANGE 1 KHz. IT CAN BE USE 5-20 AMP BATTERY SIZE : 3" X 2" H 3/4" weight 50 grams INSTRUCTION NOTE: DO NOT POWER THE UNIT WITHOUT CONNECTED TO BATTERY.....IT WILL DAMAGE THE DESULFATOR 1.) Install the Red ball clip to the positive (+) terminal on your 12 volt battery. 2.) Install the Black ball clip to the negative(-) terminal on your 12 volt battery 3.) Plug in your 12 volts adapter to DESULFATOR input (DO NOT PLUG IN ADAPTER BEFORE CONNECT TO BATTERY, IT WILL DAMAGE THE UNIT) 4.) Verify that the red LED is on, you might also be able to hear a "buzzing" noise. If use volt meter the reading will be higher than normal, do to the high spike pulse. 5.) The best results for recovery will occur within the first weeks. If left connected longer, desulfating will continue but at a slower pace.