MG Chemicals 8327GF41 - Liquid Thermal Gap Filler, Silicone, 46mL Dual Pneumatic Cartridge

Pay with

About MG Chemicals 8327GF41 - Liquid Thermal Gap

8327GF41 LIQUID THERMAL GAP FILLER, SILICONE is a two-component, flame retardant, thermally conductive silicone gap filler. It is a smooth, non-sagging paste that stays firmly in place after being dispensed. The cured product creates a thermal path that efficiently dissipates heat from electronic devices. It retains its softness after curing which maximizes stress relief during thermal cycling. 8327GF41 can be used as a liquid alternative for prefabricated solid thermal pads. If lower viscosity is required, use 8327GF25. For Use With: a) Pneumatic Dispensing Equipment b) MG Cat. #8DG50-1-1 Dispensing Gun and Cat. #8MT-50 Mixing Tips for dispensing Gun Application Instructions: Read the product’s SDS before using it (downloadable at www. mg chemicals ). Cartridge To insert the cartridge in the gun (MG 8DG-50-1-1), see the Dispensing Accessories Application Guide. 1. Twist and remove the cap from the cartridge. Do not discard cap. 2. Dispense a small amount to ensure even flow of both parts. 3. (Optional) Attach a static mixer. a. Dispense and discard 5 to 10 mL of the product to ensure a homogeneous mixture. b. After use, dispose of static mixer. 4. Without a static mixer, dispense material on a mixing surface or container, and thoroughly mix parts A and B together. 5. To stop the flow, pull back on the plunger. 6. Clean nozzle to prevent contamination and material buildup. 7. Replace the cap on the cartridge. Cure Instructions: Allow to dry at room temperature for 24 hours, or after letting sit for 5–10 minutes, cure the gap filler in an oven at one of these time/temperature options: 50 minutes @ 70 ˚C 25 minutes @ 100 ˚C. Store between -10 and 40 ˚C in a dry area, away from sunlight (see SDS).