Apollo 75-100 Series Bronze Ball Valve with Automatic Drain, Two Piece, Inline, Lockable Lever, NPT Female

Pay with

Apollo 75-100 Series Bronze Ball Valve with Features

• Made of bronze for higher strength and corrosion resistance than brass

• Automatic drain allows release of air pressure from pneumatic system to atmosphere

• Lockable lever handle can be locked in open or closed position

• Pounds per square inch (gauge) (psig) rating of 600 for water, oil, and gas (WOG) and 150 for saturated steam

• Female National Pipe Taper (NPT) threads on both ends for use with male threaded pipes

About Apollo 75-100 Series Bronze Ball Valve With

The Apollo 75-100 series two-piece inline ball valve with automatic drain is made of bronze and has a lockable lever handle and female National Pipe Taper (NPT) threaded connections on both ends. This valve is made of bronze for higher strength and corrosion resistance than brass. This valve is primarily for use in pneumatic applications; it has an automatic drain for releasing air pressure from the pneumatic system to which it is connected. When the valve is in the "on" position, the drain vent is closed; when the valve is in the "off" position, air from the downstream system is vented to the atmosphere. This valve has a zinc-plated steel, lockable lever handle that can be locked in either the open or closed position using a portable lock (not included). The pounds per square inch (gauge) (psig) rating for this valve is 600 for water, oil, and gas (WOG) and 150 for saturated steam. It is inline for connecting two pipes going in the same direction and has NPT threads on both ends for creating tighter seals than straight threads. Reinforced polytetrafluoroethylene (RPTFE) seats and multifill polytetrafluoroethylene (MPTFE) stem packing reduce the risk of valve leakage. This ball valve is standard (or regular) port for reduced valve size and cost and has a working temperature range of -20 to 450 degrees Fahrenheit. This valve is for use in water and air applications only and meets standard MSS SP-110 for quality assurance. Ball valves use a spherical disc to control the flow between pipes, tubes, or hoses. Flow is allowed when the hole that pierces the ball-shaped disc is in line with the inlet and outlet of the valve. Flow is blocked when the ball is horizontally swiveled 90 degrees, so that the hole of the ball is perpendicular to the opening of the valve. Ball valves can be referred to as full port or reduced port (also known as regular or standard port) depending on the inner diameter of the valve. A ball valve is full port if the hol