X

Yootop 200 Pcs Infrared Diode, DC1.5-5V 80mA 0.1W LED IR 940nm Emission Diffuser

Product ID : 41696983


Galleon Product ID 41696983
Model
Manufacturer
Shipping Dimension Unknown Dimensions
I think this is wrong?
-
859

*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown

Pay with

About Yootop 200 Pcs Infrared Diode, DC1.5-5V 80mA 0.1W

For detailed product parameters, please refer to the attached picture (2). Welding conditions: - Wave Soldering or Dip Soldering. Please complete the soldering within 5 seconds at a temperature of 260 ° C. At the same time, please avoid immersing the resin part in the tin furnace. - Iron Soldering: Use a 30w soldering iron, whose tip temperature should not be higher than 350 ° C, and soldering is completed within three seconds. - Reflow Soldering: NOT APPLICABLE. NOTE: The soldering point must be more than 2mm from the bottom of the resin part. Do not apply external force to the product when soldering; please be careful to prevent the pins from being corroded, otherwise it will cause soldering difficulties; it is recommended to use it early and not to store it for too long. Precautions: - The mounting hole pitch on the circuit board must be consistent with the product pin pitch, otherwise there will be a risk of damage to the internal circuit of the product. - Cutting the pins under high temperature will result in poor performance. Please reduce the pins to normal temperature or cut the pins before soldering. - Pin bending must be completed before welding, and the bend must be more than 2mm from the bottom of the resin part. - Please pay attention to protect the emission surface of the infrared emitter. Dirt or abrasion will affect the emission effect. It is recommended to wipe or impregnate with alcohol at normal temperature for no more than 3 minutes. - This product is a static-sensitive component. Please pay attention to anti-static when using it. Ground the workingbench through a conductive pad with a resistor; the tip of the soldering iron must be grounded; an ionizer is recommended.