Flowline DX10-00 EchoPod (Blue) Voltage& Frequency Trans.-1.25m Range, 1" NPT

Pay with

About Flowline DX10-00 EchoPod (Blue) Voltage& Frequency

Echopod's relays can be configured on a single set point alarm or latched on two sets for automatic fill or empty in Simplex or duplex control modes with fail-safe logic. The embedded controller can replace external control hardware. The sensor is well suited for a wide range of corrosive, sticky or dirty Type media. Echopod is broadly selected for day tanks, sumps, IBC totes, lift stations and mini-bulk storage applications. DL24 ultrasonic multifunction transmitter, switch & controller the general purpose, ultrasonic sensor provides non-contact level detection up to 98.4'' (2.5M) with 4 spot 60 VA 1a relays and a two-wire 4-20 MA level measurement output. DL14 ultrasonic multifunction transmitter, switch & controller the general purpose, ultrasonic sensor provides non-contact level detection up to 49.2'' (1.25M) with 4 spot 60 VA 1a relays and a two-wire 4-20 MA level measurement output. DS14 ultrasonic switch & controller with (4) relays the general purpose, ultrasonic sensor provides non-contact level detection up to 49.2'' (1.25M) with 4 spot 60 VA 1a relays. The DS14 directly replaces contact switches connected to a PLC with 1-4 discrete points for easy design conversion or field retrofit. DX10 ultrasonic sensor with voltage & frequency output the general purpose, DX10 ultrasonic sensor provides non-contact level measurement up to 49.2'' (1.25M) with a 0-5 VDC, 0-10 VDC or 976-2000 Hz. Frequency output. Select the voltage output to directly replace a contact measurement sensor connected to a PLC analog input. Select the frequency output to replace a contact measurement sensor or switch assembly, and eliminate the cost of an analog input card by connecting the DX10 to a PLC discrete input. DL10 ultrasonic transmitter with 4-20 MA output the general purpose, DL10 ultrasonic sensor provides non-contact level measurement up to 49.2'' (1.25M) with a 4-20 MA output. The DL10 directly replaces contact measurement sensors connected to a PLC analog input C.