We specialize in hard to find items
All Categories
PepeTools Ultra Power Electric Combination Rolling Mill 130mm, MADE IN THE USA
Share Tweet
of brand new stock?
or
Need this item ASAP?
Check if this is available on Amazon
or available in other sites
Send us the link so we can buy for you
PepeTools Ultra Power Electric Combination Rolling Features
-
Center Dial 0-100: Regulates speed at which the rollers turn; Forward/Stop/Reverse switch, On/Off Switch
-
MAXIMUM ROLLER OPENING: 0-7.5mm; Rollers: 130mm Length x 65mm Diameter - “Mirror” finished and induction hardened to 60-62 HRC
-
Rollers: SQUARE (mm): 1.0, 1.5, 2.0, 2.5, 3.0, 3.5, 4.0, 4.5 ; FLAT: 66 wide x 65 diameter; ELLIPSE, HALF-ROUND(mm): 2.5 x 1 and 3 x 1.25 and 4 x 1.5
-
Rolling Mill Body is one-piece precision cast construction for ULTRA strength and durability; Industrial Grade - Heavy Duty Worm Gearbox* - Rated 12,000 Hours Continues Duty
-
Production Speed 0-12 RPM; Production Output - 7.5 Ft/min or 2.3 m/min; Roller Opening: 0-7.5mm
About PepeTools Ultra Power Electric Combination Rolling
epe Ultra Mills designed for cold rolling of nonferrous metals to produce uniform thickness and bright finish. You will be able to reduce thickness (gauges) of sheet metal and wire. Transfer textures to your metal, and many other related tasks. The "T" bar at the top of the Rolling Mill used to open or close the rollers. When completely closed the rollers, should measure "true" cylindrically. This means they should touch with no visible gaps. Should there ever be a gap, meaning the rollers are not "true", simply remove the two small screws holding the "T" bar cover , pull the "T" bar handle off and turn the large gears to move the roller(s) down until there is no visible gap, making them "true", then re-install the "T" bar and cover. To roll metal: Open the rollers to accept the metal and close the rollers around the metal using the "T" bar until the rollers touch and hold the metal. Set the indicator dials on the large gears to "0" (zero), Indicator Dials are on the top of each Rolling Mill. Turn on the Power Mill and Select Forward. Select Speed at which the Roller moves with the Center Dial (0-100). Tests pass the metal through. Once the test pass been completed, you will want to turn the "T" bar clockwise one quarter of the space between the markings on top of the gears, any greater distance could damage the mill. Continue to pass the metal through the rollers until the desired thickness is achieved.
