X

DW705 DW708 Brushes Replacement for Black&Decker Power Tools/DeWalt Power Tools, Upgraded Version Motor Miter Saw Brushes Set Replace 145323-03 145323-02 145323-06(2 pairs)

Product ID : 44601073


Galleon Product ID 44601073
Model
Manufacturer
Shipping Dimension Unknown Dimensions
I think this is wrong?
-
No price yet.
Price not yet available.

Pay with

About DW705 DW708 Brushes Replacement For Black&Decker

Good performance: (1) Long service life without wearing away commutator or slip ring. (2) It has good commutation and current collecting performance, so that the spark is suppressed within the allowable range, and the energy loss is small. (3) When the brush is running, it is not too hot, the noise is small, and it is not damaged. (4) During the operation, a uniform, moderate and stable oxide film can be quickly formed on the surface of the commutator or the collector ring. How to tell if it needs to be replaced:Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. The carbon brush should be replaced when the following situations occur: 1. Serious wear (less than 1/3 of the original length); 2. Serious damage; 3. The contact surface between the carbon brush and the slip ring is less than 70%.Note:1. If the lead-out wire of a carbon brush is covered with an insulating tube, it shall be installed in an insulated carbon brush holder; if the lead-out wire is a bare copper wire, it shall be installed in a grounded carbon brush holder.2. When installing the carbon brush on the carbon brush holder, pay attention to the direction of the curved surface. If it is installed, the contact surface will be too small, and the power generation will be weak or not.3. The carbon brush should be able to rise and fall freely in the carbon brush holder. If the card is issued, remove the excess.4. The carbon brush spring should be pressed in the center of the carbon brush to prevent uneven wear due to uneven force.5. The contact area between the carbon brush and the commutator should not be less than 3/4 of the total contact surface, and the carbon brush must be free of oil.Compatible with models: DeWalt Part Number: 145323-03 Used with the following DeWalt models: DW705-220 DW705S DW705 DW708 DW744S DW744 DW361 DW357 DW358 DW359 DW360