Drill Charging Station | Drill Storage | Wall Mounted Cordless Drill Organizer | Power Tool Storage - Power Drill Toolbox Screwdriver Cordless Drill Organizer - Tool, Parts Craft Organizer

Pay with

About Drill Charging Station | Drill Storage | Wall

Features: ♣ 2 sufficient storage space for placing tools and parts, and 5 hanging slots for electric drills ♣ The surface and edges of the board are polished,smooth and will not scratch your fingers ♣ 48 screws for multi-dimensional connection of product parts, sturdy and strong load-bearing capacity ♣ Our products are made of high-quality hard wood and surface treatment technology, which makes the product moisture-proof, anti-erosion, strong and durable. Specifications: Material:high-quality wood Color: Yellow Size:19.5in/495mm x 8.3in/210mm x 12.2in/310mm Product parts and installation steps A x 4 ; B x 4 ; C x 1 ; D x 1; E x 1 ; F x 1 ; G x 1 ; H x 2; I x 40 ; J x 4 ; K x 4 Step 1 Find the A and B plates, the B plates are placed horizontally, the A plates are placed vertically, and the two plates are locked with I. In the same way, four A plates and four B plates are assembled. Step 2 Take out the C board,The two screw holes above the A board are aligned with the two screw holes of the C board and tightened with I. Step 3 Align the back of the above installed module with the 6 holes in the lower part of the D plate and tighten with I . Step 4 Place the E-plate horizontally and align the two screw holes in the middle of the D-plate and tighten with I. Assembled into new modules. Step 5 Take out the G plate and the F plate, connect the H plate to the bottom of the G plate (without the side of the wire slot).Connect the H plate to the bottom of the F plate with I, and keep the two H plates in opposite directions. Step 6 Install the G and F plates on the left and right sides of the new module respectively, and tighten them with I . Step 7 Hold the D plate against the wall, align the 4 holes of the D board and use J to drive into the wall. Then use K through t