Maker Drive 1A Dual Channel H-Bridge Motor Driver PWM Speed Controller for Beginner Better Than L298N

Pay with

About Maker Drive 1A Dual Channel H-Bridge Motor Driver

If you are a beginner or newbie that needs a simple motor driver to drive DC brushed motor for building mobile robot or other purposes, you might face some of these obstacles: Burning your Motor Driver - Many low cost motor driver like L298N does not comes with Reserve Polarity Protection. Too Bulky -L298N board comes with BIG heat sink and take up too much space. Hard to test and troubleshoot No Proper 5V Output- L298N board will not provide stable 5V output Here is Our Solution: Maker Drive Fool Proof (Peace of Mind)- Reverse Polarity Protectionat Vin/Vmotor/Vbatt (Power for motor) terminal. Compact Design- Size of a passport photo. 4 Test Buttons (2for each channel) -Easily test the motor or your mechanism without any controller or coding. 4 Indicator LEDs (2for each channel) -Easily test your coding and wire connections. Proper 5V Output with Wide Voltage Input Range as low as2.5V Regenerative Braking Control- provides better control over motor speed. Features: Compatible with Arduino, Raspberry Pi, BeagleBone, ESP8266, ESP32, etc. Dual channel, Bi-directional control motor driver Support motor voltage from 2.5V to 9.5VDC Maximum current up to 1.0A continuous and 1.5A peak( 5V Output (200mA) to power the controller. Inputs compatible with 1.8V, 3.3V and 5V logic (Arduino, Raspberry Pi, etc). Solid state components provide faster response time and eliminate the wear and tear of mechanical relay Regenerative Braking Speed control PWM frequency up to 20KHz (Actual output frequency is same as input frequency) Dimension: 43mm(W) x 35mm (L) x 14mm (H)