12V 5T Automatic Electric Car Jack Scissor Lift with Remote Control for Vehicle Repairing and Tire Replacing

Pay with

About 12V 5T Automatic Electric Car Jack Scissor Lift

1. the use of electric jin items: (1) car parked on a level surface, turn off the engine, but do not forget to tighten the hand brake. (2) two ways the electric jack is connected to the 12V power supply: I. using cigarette lighter connection: the cigarette lighter plug cord into the cigarette lighter socket and the other end of the 5.5mm plug to 5.5mm plug seat on the electric jack. (Note: The cigarette lighter fuse rated current of not less than 10A) II. using the vehicle's battery is connected directly: the cigarette lighter plug cord into the belt clip at one end of the battery in the cigarette lighter socket, while the other end of the battery clip battery clamps red " " (positive) on the black clip and battery "-" (negative), and then plug the other end of the cigarette lighter plug wire 5.5mm 5.5mm jack plug into the electric plug socket. (3) use: In determining well after the first few steps, you can start jacking operation. Hold the remote control, if necessary, press the button on the remote control, "x1" said the rose, "x2" said the decline, "x3 " means stop. ) (4) the lifting process, should be carefully observed dynamic jacking ensure electric jack does not tilt, until the wheels leave the ground 20mm, the wheels can rotate freely should stop jacking, replace the tire. 2. the use of electric wrench: (1) When the wheels leave the ground to be replaced, will take a good supply of electric wrench (2) selecting the right sleeve, set into the side of the square hole axis electric wrench at the top of the head, you can loosen or tighten the bolts. (3) the desired direction of the work, choose loose, tight switch. The power switch on the left flag "ll", was the reverse direction, the right sign "|", was the clockwise direction, the middle mark "o" at the stop. With the thumb and hold the appropriate direction switch, heard 1-2 times "despair, despair" to release the thumb after the crash, the whole process about 2-3 seconds