CGA320 G1/2 CO2 Tank Refill Adapter Connector Kit For Filling Soda Maker Sodastream Tank

Pay with

About CGA320 G1/2 CO2 Tank Refill Adapter Connector Kit

Large CO2 tank Connect thread: CGA320 G1/2-14 Instructions: 1. Screw the SodaStream adapter into the main piece. 2. Connect the main piece to the donor cylinder(Large CO2 Tank).Make sure that all the valves are completely closed. 3. Screw the SodaStream cylinder into the adapter. 4. Turn the knob of the SodaStream adapter to completely open the cylinder valve. 5. Open the valve on the donor cylinder to release the gas. 6. Open the ON/OFF valve on the main piece. (Please Refer to NOTE:) 7. You will hear gas flowing into the cylinder. Refilling takes roughly 30-60 seconds. 8. Once refilling is complete,stop the CO2 by turning the ON/OFF valve. 9. Isolate the SodaStream cylinder by turning the adapter knob. 10. Release the residual gas by opening the escape valve. 11. Remove the SodaStream cylinder from the adapter. 12. Repeat the refill process for each cylinder. 13. Once finished, close the valve on the donor cylinder. NOTE: 1.SodaStream cylinders have filling protection valve to prevent you from refilling them.Unlike the other cylinder valves, this valve must be filled with a slow increase in pressure. When refilling, it is important that the pressure in the first few seconds is very low, only the cylinder valve remains open. The ON/OFF valve is therefore open at the beginning only slightly and very slowly until some gas flows through (this can heard). Wait about 10 seconds and then open a little more until it's all the way open.Wait about 30-60 seconds until you hear no gas flows, filling can be complete. If you open the ON/OFF valve too fast, you may need to close donor cylinder, bleed the line and start over. 2.If your large tank doesn't has a siphon tube,you should turn it upside down. 3.The cylinder should be empty.Pre Cooled cartridges will get quite full. Package Included: 1 x Cylinder Refill Adapter 1 x Fitting set