All Categories
🌝Specification: WADEO 36 Inch stainless steel braided Hose Dual Valve with Gauge, the hose's work pressure is 1500 PSI and the gauge is 3000 PSI, Thread for large CO2 tank is CGA320 and thread for soda stream tank is TR21-4.
🌝Built-in Pressure Gauge: The product is equipped with pressure gauge, can clearly see the gas pressure range, the pressure control in a safe range.There are two on/off valves in our product, one is to control CO2 from the large cylinder into the small cylinder, and the other is to release the excess gas after filling.
🌝Easy to Install and Please remember to use a spanner to tighten the connector to avoid leakage. ❗ If the large CO2 cylinder does not have a siphon tube, then the large CO2 cylinder needs to be inverted to be inflated; in addition, the small cylinder needs to be put into the refrigerator for a while before filling.
🌝Attention: Please read the instructions before use; The big CO2 tank (donor cylinder) should have enough pressure, if it is liquid CO2, invert the big tank or freeze the soda gas bottle for a while to inflate. If the small tank still cannot be inflated even follow the instructions to operate, we recommend replacing the thin thimble tank. ❌Can not be used on paintball CO2 tank.❌Can not be used on new style CO2 bottles.
🌝When the stainless steel braided Hose expands, check that the thimble of the vial is too thick to inflate. If so, replace the thin thimble bottle,then you can use it in normal. (Or contact us)
Specification: Hose material: Stainless steel Hose length: 36 Inch/90cm Working pressure: 3000 PSI Thread For Large CO2 Tank: CGA320 G1/2-14 Fits soda stream tank thread: TR21-4 Package Included: 1 x 36 Inch Stainless steel braided hose refill station with gauge 1 x Bag of fittings 1 x Operation instruction Attention: 1.Please read the instructions before use. 2.Big CO2 tank (donor cylinder) should have enough pressure, if it is liquid CO2, invert the big tank to inflate. 3.If the small tank still cannot be inflated even follow the instructions to operate, we recommend replacing the thin thimble tank. Inflatable Steps: 1.Place the gasket in the refill connector,confirm the On/Off and Release valve are closed, rotating the pin switch of small cylinder to the top. 2.Connect the fill station connector to the big bottle and connect the small cylinder to the soda stream Co2 adapter. 3.Close the release valve and open inlet valve. 4.Rotate the pin switch of the adapter clockwise to the bottom to allow gas to enter the small cylinder. 5.After fulling of gas by the small cylinder, contrarotate the pin switch to the highest position and close the inlet valve. 6.Open the release valve and exhaust the excess gas in the hose. 7.After inflating, unscrew the small cylinder.