NGK Spark Plug Resistor Cover Cap 90 Degree LB05FP - Compatible with Honda Kawasaki Suzuki Yamaha

Pay with

About NGK Spark Plug Resistor Cover Cap 90 Degree LB05FP

NGK Spark Plug Resistor Cover - LB05F for the CB350 twin and most of Honda's other twin's from the 60's and 70's. This one has a 90 degree bend. For 14mm thread spark plugs without the terminal nut. Rubber waterproof boots to seal out the elements. We recommend using non-resistor type spark plugs when using resistor caps on vintage Honda's. NGK spark plug resistor covers are the best protection against radio frequency interference Rubber waterproof boots to seal out the elements, so the engine won't cut out if it rains. For use with 7mm diameter plug wires Fits all Honda Twins from the 60's and 70's plus a lot of single cylinder 4 strokes and 2 strokes Sold Individually NGK Part Number: 8030Replaces Honda Part Number: 30700-098-153 Installation tips: Remove terminal nut before installing new spark plugs. It's screwed onto the top of the spark plug.Put a light coating of anti-seize on the spark plug threading before installing. After all, you're threading a steel part into a aluminum engine case.Don't over tighten the spark plug, 1/8 to 1/4 turn past finger tight.When using the old spark plug wires, trim them back 1/4" - 1/2" to expose fresh wire, then using a pick type tool, fan out the wires before threading on the new resistor cover.Twist on the new cover about 3 full turns and give it a tug to make sure it's snug. Also fits tons of other bikes. Check the part number and photo to see if it's what you need.