VDIAGTOOL Coating Thickness Gauge VC100 with Digital LCD Backlight Display Coating Depth Detector Measuring Paint Depth Car Paint Tester for Car Accident Detection

Pay with

About VDIAGTOOL Coating Thickness Gauge VC100 With

Technical Parameters: Measurement Range: 0-1.80mm/71.0mil Resolution: 0.05mm/2mil Measurement Error: ±0.1mm Minimum Diameter of Substrate: Φ50mm Minimum Thickness of Substrate: 0.5mm Work Temperature Range: 18-30°C Work Humidity Range: 10-80%RH Batteries: CR2302*2(NOT included) Outline Dimension: 38*87*22 mm/1.5*3.43*0.87 inches Weight: 63.98 g/0.14 lb Button Functions: 1.Button "CLR": Turn on/off, clear. 2.Button "UNIT": Unit Switch, backlight. Operation Instructions: 1. Measurement preparation Open battery cover and load two CR2032 button batteries; Pay attention to positive and negative pole. 2. Turn on/off Leave the instrument hang in the air and press "CLR" button to turn it on, LCD full screen display, which means it enters the measurement state. Then long press"CLR" button to turn it off. Note: Keep it away from the substrate when starting up. 3. Measurement Press the probe onto the coated metal substrate lightly, ensure that the instrument should be perpendicular to the surface of the object that being measured. Note: When the probe was pressed on the substrate, the LCD will display "---" , then you must wait unit the measurement value displayed the LCD, then remove it from the substrate. If removing before a value is displayed, it will display the last measured value. 4. Unit selection After start-up, short press "UNIT" button to select measurement unit mm or mil. 5. LCD backlight After start-up, long press "UNIT" button to turn on/off the backlight. 6. Clear screen data After start-up, press "CLR" button to clear the data displayed on LCD screen. 7. Power off automatically The instrument will power off automatically if 2 minutes no operation after start-up. And it will power off automatically as well after 5 minutes start-up, even when you are operating it.