All Categories
Instructions for Use Step1, It is better to use a drill rather than a screwdriver. Step2, Please press the reverse button on the drill to prepare the electric drill for use.(Don't need to reset the reverse button the whole process.) Step3, After drilling a little hole into the damaged screws by drill bits (no limits to the drilling speed), you should install the corresponding size of the extractor and change the speed of the electric drill to below 200 RPM, then remove the damaged screw counterclockwise until the screw is released. Step4, Please use the BIT HOLDER for drill bits or extract bits of size #1-#4. The adaptor (ADP) should be installed but not together with the adaptor(ADP) for drill bits or extract bits of size #5-#8. Wide range of sizes of screws or bolts as shown below: #1 Remove screws or bolts Diameter 6~12mm. #2 Remove screws or bolts Diameter 5~10mm. #3 Remove screws or bolts Diameter 4~8mm. #4 Remove screws or bolts Diameter 3~5mm. #5 Remove screws or bolts Diameter 3.5~6.5mm. #6 Remove screws or bolts Diameter 3~5.5mm. #7 Remove screws or bolts Diameter 2.5~4.5mm. #8 Remove screws or bolts Diameter 2~3.5mm.Christmas Gift