All Categories
Moshbu Woodworking Trimming Machine Engraving Flip Board, Multi-functional DIY Fine Tuning Aluminum Router Table Insert Board Trimmer Wood Engraving Machine Router Board Specification: Category: Woodworking Trimming Machine Flip Board Thickness: 10 mm Round Diameter: 75 mm Internal Hole Distance: 85 mm External Hole Distance: 270 x 205 mm Material: Aluminum Alloy + Plastic Ring Weight: 1700 g Product Size: 30 x 23.5 x 0.95 cm Packing Size: 33 x 25 x 1.5 cm Flip-Chip Installation Steps: 1. Use a Phillips screwdriver to unscrew the bottom four screws and the middle two screws to remove the black plastic plate. 2. Remove the black screw and the black limit seat (Note: the limit seat thread reversal) 3. Find the right hole (not too close to the side, otherwise the hexagonal screw countersunk will not fit in) 4. Make a small hole with a diameter of 8-9mm, and be careful not to drop the aluminum chips into the machine. 5. Install the supplied brass nut, screw it into the screw, and then screw in the hex nut limit. After the adjustment of the lift adjustment, install the flip-chip. Note: 1.This product can be used in the general electric trimming machine installation table. You can refer to the size in the picture and the hole distance of the console to choose the correct type you want. 2. Please allow 0-3mm error due to manual measurement Package Included: 1 x Flip Board 1 x 2 Circular Limit Rings 1 x 1 Package Auxiliary Tool