We specialize in hard to find items
All Categories
BIQU 3D Printer Part Ultra Silent TMC2208 V1.0 Stepper Motor Driver Module with Heatsink for Control Board MKS GEN V1.4 Ramps 1.4 Ramps 1.6 (Pack of 5pc)
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
About BIQU 3D Printer Part Ultra Silent TMC2208 V1.0
Specification : Interface: Step/Dir Configuration: CFG Pins or UART Microplyer/ Microsteps:up to 1/256 Logic Voltage VIO: 3-5V Motor Voltage VM: 5.5V-36V Motor Phase Current: 1.2A RMS,2.0A Peak VM always needed: Yes Internal V-Regulator: enabled RDSon: Less than and equal to 0.3 Ohm StealthChop(quiet):YES SpreadCycle: YES CoolStep: no StallGuard: no DcStep: no Instructions: 1. When used on Ramps1.4 or MKS Gen,please remove the 3 jumpers under socket. 2. Pay attention to direction, do not insert wrongly. 3. Heat sink directly attach on the PCB. 4. The motor direction is opposite to that of 4988 and 8825, please adjust the firmware or adjust the motor wiring if you want to replace 4988. Packing List: 5x TMC2208 Driver 5 x Heat Sink
