RESIONE 3D Printer Resin, C01 Dental Castable Resin High Precision for Direct Investment Casting Excellent Fluidity No Post-Curing Required for 3D Printing

Pay with

RESIONE 3D Printer Resin, C01 Dental Castable Resin Features

• 【Used for direct investment casting】C01 resin is specially designed for dental use, suitable for centrifugal casting at 900°C with no ash residue.

• 【High precision】Whether it is form accuracy or dimensional accuracy, C01 is excellent, ensuring that the cast crown, bridge or dental bracket will fit perfectly in the patient's mouth.

• 【Excellent fluidity】The viscosity of the resin liquid is only 100mpa.s, which is close to the fluidity of water, which greatly saves the waiting time of the exposure gap and speeds up the 3d printing speed. And the characteristics of low viscosity make the details of the prints clearer and the shape accuracy higher.

• 【No post-curing required】 C01 resin has high rigidity when it is first formed, and the liquid is easy to clean, and the surface of the printed part is not sticky after washing, so it does not need post-curing, saving time.

• 【Supports are easy to remove】 Just the right mechanical properties make the C01 prints do not need too thick supports, so the supports are easily wiped off, leaving no pits on the surface, saving manual grinding time.

About RESIONE 3D Printer Resin, C01 Dental Castable Resin

C01 is a transparent green castable resin for dentistry. It is mainly used for direct investment casting of nickel-chromium and cobalt-chromium casting alloys. It is suitable for printing partial dentures, buckles, and crowns. This resin is added with plastic material and does not contain wax. It provides high hardness, sharp details, and extremely high precision for the printed parts. The exquisite partial frame with thin features and some casting flexibility can also be successfully printed and cast.RESIONE C01 Dental Castable ResinPrinting SettingsLayer height: 0.05mmBottom exposure time: 60-90sNormal exposure time: 2.5-5.1sCleaning and Post-curingCleaning tools: Ultrasonic or 3D printing special cleaning machineCleaning time: Less than 1minCleaning solvent: 95% Ethanol or IPAPost-curing: No needShore Hardness:78D Tensile Strength: 26MPa Flexural Strength: 39MPaFlexural Modulus: 400MPaNotched IZOD: 6J/mElongation at Break: 4.5% Viscosity（25℃）: 100mpa.s PrecautionsUSE：1. Operating temperature: 25~35℃,68℉~95℉2. Shake well before each use. If the resin is very viscous, preheat the bottle with 60-80℃ warm water before shaking it.3. Please wear nitrile rubber gloves during operation and keep the operating environment well ventilated.4. Do not use resin near windows, balconies, or other strong ultraviolet environments.5. If you accidentally get resin into your eyes, mouth, or nose, rinse immediately with plenty of water and consult a doctor.6. The resin remaining on the skin can be washed with soap, hand sanitizer, etc.Waste liquid：1. If the resin is no longer needed, please pour it into a transparent container (pour a small amount at a time), then place it in