Gobrico Kitchen Cabinet Pulls Satin Nickel Stainless Steel Dresser Drawer Handles, Modern T Bar Knobs for Cabinet, 6-3/10" (160mm) Hole to Hole - 50 Pack

Pay with

Gobrico Kitchen Cabinet Pulls Satin Nickel Features

• Material:Made of stainless steel. Hollow construction.Strudy and durable，anti-rust for your long-term use

• Modern Style.T Bar Euro style in satin nickel.For your cabinet,cupboard,wardrobe,dresser,drawer,shoe cabinet,etc

• Measurements:Holes Distance 6-3/10 inch(160mm),Overall Length 8-4/5 inch(224mm),Diameter 1/2 inch(12mm),Projection 1-1/4 inch(32mm)

• 2 Set of Screws Included:1" screws included,fit for door thickness 17.5mm-21mm(0.68"-0.83"). 1-3/4"-long screws included,fit door thickness 34mm-39mm(1.34"-1.54")

• After-Sales Service:We refund or send replacement for any quality problem order.Please contact us through the message

About Gobrico Kitchen Cabinet Pulls Satin Nickel

Product Discription: Include:50pcs handles and 100pcs M4 installing screws Material:Hollow stainless steel Finished Color:Brushed Satin Nickel Tips:The 1"/25mm-long screws come with the handles are suitable for the door in the thickness 17.5-21mm(0.68in-0.83in). If you need longer screws, please contact us Installation Instuction: Step One:Choose the right size.Cabinet knobs and cabinet pulls are typically installed between 2 1/2 and 3 inches from the corner of the cabinet doors furthest from the hinges. For upper cabinets, this is the lower corner; on base cabinets, this is the upper corner. Knobs and pulls installed on a kitchen drawer front are typically centered in the middle of the drawer, both top-down and side-to-side. Step Two:Drill the Holes.Use a drill bit that is the same size as the screws being used with the knob or pull. Drill from the front of the cabinet toward the back. Step Three:Install the Handles.The knob hardware itself is held in place on the front of the door while the screws are inserted into the hole in the door from the back. Screw from the back into the pull or knob until it is snug against the door and doesn't rotate when you attempt to turn it. The screw head should be flush to the backside of the door. If you need to replace the old handles, please remove the old handles and measure the hole to hole distance on the door/cabinet to choose the right size.