OCEANBROAD 4 Pieces x (15in x 10in) Non-Slip Deck Pad Grip Mat, with 3M Adhesive Backing Trimmable EVA Traction Anti-Slip Foam Pad Sheet for Boat Kayak Canoe Yacht Pool Step SUP Board, Black

Pay with

OCEANBROAD 4 Pieces x (15in x 10in) Non-Slip Deck Features

• SUPER NON-SLIP TRACTION: This trimmable EVA pad is cut with diamond grooves. It provides a nice textured surface with excellent grip. It’s a perfect anti-slip deck mat for your kayak, boat, canoe, pool step, SUP paddle board, surfboard, skimboard, etc.

• COMFORTABLE: This traction grip pad is made of top-grade EVA foam. Soft, yet elastic, it’s very comfortable to step or sit on it. It helps to reduce your foot fatigue as well as provides the extra traction you want.

• DURABLE: The premium quality EVA pad sustains tear and wear longer than normal. Along with that, the backing adhesive is original 3M, of marine grade. It’s almost not possible to peel off.

• VERSATILE: 15’’x 10’’ per piece, 4 pieces per set, this grip mat is very suitable for DIY in various circumstances. Just remember to draw the outline accordingly to help with a more precise cutting.

• WORRY FREE PURCHASE: OCEANBROAD offers complete customer satisfaction of replacement or refund for any quality issues.

About OCEANBROAD 4 Pieces X (15in X 10in) Non-Slip Deck

DESCRIPTION: The OCEANBROAD non-slip traction mat is made of top-quality EVA pad and original 3M marine grade adhesive. It’s a durable and comfortable grip deck pad to provide extra traction for difference place such as the deck of kayak, boat, yacht, canoe, SUP paddle board, pool steps, stair steps, or other types of slippery areas. SPECIFICATIONS: 15 inches x 10 inches x 0.2 inches / piece 4 pieces pack INSTALLATION INSTRUCTION: -Draw the outline first, if you need to cut them to some other shapes. -Clean up the surface (not recommended for un-flat surface), make sure it’s dry and dust-free before you put the pad onto it. -Peel off the backing a little bit from one corner, stick it on and double check, make sure the position’s correct, adjust it if not (since it’s only a very small corner of it, the pad can still be taken off without hurting the adhesive). -Once the piece is secured with 2 corners at the correct positions, peel off the side where the 2 corners are, secure the whole side of it. Then start to peel off the whole backing from underneath gradually, meanwhile keep pressing on the top with the other hand to make sure the pad well sticks to the surface without air left inside. -In case, there’s air inside after the pad’s applied, make some punctures with a needle over it, let out the air, press hard. -Double check the whole piece is well attached. Extra pressing around the edges is recommended.