LED Tail Brake Lights Turn Signal Integrated Compatible With YAMAHA MT-09 / MT09 SP 2021 2022， MT-10 / MT10 SP 2022(Clear)

Pay with

LED Tail Brake Lights Turn Signal Integrated Features

• -Condition:Brand New Integrated LED Tail Light Turn signals Blinker -High brightness, red light and amber light. It includes brake light / driving light / turn singal light

• -There are two yellow wires for turning signal, they need you link them manually. If the light twinkle quickly or don't work, you need to linked a LED resistance.

• -Material: Acrylic clear len/ ABS black cover -This item is aftermarket, so we don't hope you compare our product to the O.E.M

• -LED light usually use little bit power, sometimes after you install, the LED light blink very fast or not blink, if you have this issue, you may need LOAD RESISTOR to put between the LED lights and POSITIVE, usually go around 6 ohm LOAD RESISTOR will make it work, Package include!

• -Compatible With YAMAHA MT-10 2022 Compatible With YAMAHA MT-10 SP 2022 Compatible With YAMAHA MT-09 2021 2022 Compatible With YAMAHA MT-09 SP 2021 2022

About LED Tail Brake Lights Turn Signal Integrated

Description:-Condition:Brand New Integrated LED Tail Light Turn signals Blinker-High brightness, red light and amber light. It includes brake light / driving light / turn singal light-There are two yellow wires for turning signal, they need you link them manually. If the light twinkle quickly or don't work, you need to linked a LED resistance.-Material: Acrylic clear len/ ABS black cover-This item is aftermarket, so we don't hope you compare our product to the O.E.M-Available color: Smoke / Red / Clear-Packing included: A piece Tail Light Turn Signals.-Color may have 5% different from the photos shown online.-Please confirm if the item fit your bike or not before you place an order.Fitment:Compatible With YAMAHA MT-10  2022Compatible With YAMAHA MT-10 SP 2022Compatible With YAMAHA MT-09 2021 2022Compatible With YAMAHA MT-09 SP 2021 2022Wiring Diagram applicable to most bikes:Black Wire(Negative),Green Wire(Brake)Red Wire(Running Light)1. Connect one end of the resistor to the ground wire on your turn signal harness from your bike.2. Connect the other end of the resistor to both the YELLOW wire from our taillight and the positive turn signal wire from your turn signal harness from your bike.3. Repeat the same process for the other side.To use the red connectors, place one wire inside along one channel, place another wire inside alongthe other channel. Push down the metal pin as it will make a small cut on each wire bridging the connectors.if you are using the resistors, place one end of the resistor in the middle of either channel along with the one wire