GraniTile 360~8oz. epoxy. New, and Even Stronger Than Our II 29! for Difficult Surfaces Like Tile Marble Porcelain Ceramic. Chipped Corners. Crack Repair. Fills or Rebuilds. Tintable with EZ-Tint

Pay with

GraniTile 360~8oz. epoxy. New, and Even Stronger Features

• Marble edges are non-porous and will need to be lightly drilled or really roughed-up to provide a bonding surface for the epoxy. GT 360 is an impenetrable solid shield that is an unbreakable bond. Non-toxic, food-safe and simple to use. For years. The #1 install and rapid-repair epoxy used by the pro's. The extended 15 minute application time allows for proper alignment and application for repairing or installing without needing to rush...then instantly dries after the application time is up

• Use our EZ-TINT pigments, (not included) to match your stones color. Tight seams with even breaks do not require tint to be added.

• Remember, DISCOVER WHICH OF OUR PRODUCTS YOU NEED: It's easy...Chips, large cracks, missing pieces to rebuild missing pieces, or fill craters you need the paste like body of GT 360 .

• The dried excess easily razors off finished surfaces so no taping required.

• Paste consistency makes using this product a breeze and tintable with our EZ Tints or even food coloring!

About GraniTile 360~8oz. Epoxy. New, And Even Stronger

Marble is non-porous. Marble will need to be lightly drilled or really roughed-up to provide a bonding surface. GT 360 is an impenetrable solid shield that is an unbreakable bond. Non-toxic, food-safe and simple to use. For years the #1 install and rapid-repair epoxy used by the pro's. The extended 15 minute application time allows for proper alignment and application for repairing or installing without needing to rush...then instantly dries after the application time is up. GT 360 strongly bonds to most all projects all around the house... not just stone and tile. See our EZ-TINT pigments for tinting instructions MISSING CHIPS: After tinting, fill the epoxy into the repair area. Shape into place. Let dry. Razor off the excess and continue shaping with safety razor. CHIPPED STONE: No tint needed if you have a clean break where the piece can be reattached tightly. Apply epoxy to one side and push firmly into place. Always clamp for the most invisible of seams or tape down tightly. CRACKS: Cracks must be wide as a credit card for the epoxy to be able to fill the crack. Tint after mixing and fill crack to the surface. Allow to self level for a glossy finish or once excess is dried, razor the surface level for a matted, travertine type finish. Remains flexible for hours if you decide to dig out attempt until you get exactly the finished look you desire. COUNTER INSTALLATION: Joint lines do not need to be taped since amazingly, the dried excess will not stick to the slick finished surfaces. Simply mix equal amounts of Resin and Hardener and apply to one or both edges. Clamp for maximum bond. Do not remove uncured excess epoxy. Simply razor off the excess once excess is dry-to-touch in apx. 45 minutes after it was mixed.