WPT688 HVAC Blower Motor Resistor Connector Wire Harness Pigtail Assembly S1763 Compatible with Ford Explorer Escape Expedition Mustang Fiesta Lincoln Mark Lt Navigator, Mercury Mariner

Pay with

About WPT688 HVAC Blower Motor Resistor Connector Wire

Compatible with vehicles below: 2006-2010 Ford Crown Victoria 2008-2014 Ford Escape 2007-2014 Ford Expedition 2007-2010 Ford Explorer 2008-2010 Ford Explorer Sport Trac 2004-2018 Ford F-150 2004 Ford F-150 Heritage 2011-2013 Ford Fiesta 2005-2007 Ford Five Hundred 2009-2011 Ford Flex 2004-2007 Ford Freestar 2005-2007 Ford Freestyle 2006-2014 Ford Mustang 2005-2011 Ford Taurus 2008-2009 Ford Taurus X Rear 2006-2008 Lincoln Mark Lt 2009-2011 Lincoln Mks 2010-2011 Lincoln Mkt 2007-2015 Lincoln Navigator 2007-2010 Mercury Grand Marquis 2008-2011 Mercury Mariner 2005-2007 Mercury Montego 2004-2007 Mercury Monterey 2007-2010 Mercury Mountaineer 2005-2009 Mercury Sable How to replace with new HVAC blower motor resistor? Safety Notes before replacement: 1.Cut off the engine and disconnect the battery. 2. Wait until the blower motor cool to room temperature. 3. The most important is clearing dust for the blower motor via professional motor detergent, please don’t use water to clean!!! 4. Wait until blower motor get dry. 5. Disconnect the electrical connector at the resistor.  Replacement note: If the new blower motor resistor didn't work or stop work in a short time after correct replacement, please check if there was too much dust with your blower motor.  Replacement: Remove the negative battery terminal. Locate the blower motor resistor on the passenger side under the dash board. It is mounted to the the blower housing near the blower motor. Disconnect the electrical connector to the blower motor resistor. Remove the screws or bolts to the blower motor resistor and remove the resistor. Installation is the reverse of the removal.