All Categories
The BE220 M8N GPS module has a flash memory function to save the configuration, which can help you do not need to reset the data next time you use it.
Note: it does not have a compass
When it is used on Raspberry Pi, it is not necessary to install the driver, but the software must be installed
If the TX LED indicator flashes, it means that the BE220 M8N GPS module is operating normally, and the PPS LED indicator flashes to indicate that the GPS module has found your location
If you have any questions, you can contact us at any time
Description User Manual Dimension : 22mm*20mm*6mm Weight : 5.3g Connector : 1.00mm spacing between the 4pins patch seat Specification Electrical Characteristics Chipset : M8030-KT Receiving Format : GPS,GLONASS,Galileo,BeiDou,QZSS and SBAS Frequency : GPS L1,GLONASS L1,BeiDou B1,SBAS L1,Galileo E1 Channels : 72 Searching Channel Sensitivityv Tracking : -167dBm Reacquisition : -160dBm Cold start : -148dBm Hot start : -156dBm Accuracy Position Horizontal : 2.0 m CEP 2D RMS SBAS Enable (Typical Open Sky) Speed : 0.1m/sec 95% (SA off) Timing : 1us synchronized to GPS time Acquisition Time Cold Start : 26s Warm start : 25s Hot start : 1s Data and Update Rate Support Rate : 4800bps to 921600bps,Default 9600bps Data Level : TTL or RS-232,Default TTL level Data Protocol : NMEA-0183, Default NMEA-0183 Single GNSS : 1Hz-18Hz Concurrent GNSS : 1Hz-10Hz,Default 1Hz Operational Limits Altitude : 50,000m Max Speed : 515m/s Max Acceleration : Less than 4g Electricityconsumption VCC : DC Voltage 3.0V-5.5V,Typical: 5.0V Current : Capture 50mA/5.0V Operating temp : -40 °C ~ +85°C Storage Temp : -40°C ~ +105°C Indicator : TX LED:blue.The data output, TX LED flashing PPS LED:red.PPS LED not bright when GPS not fixed,flashing when fixed Wiring: GND,TX output,RX input,VCC(3.0v-5.5v) Package Included 2 x BE-220 GPS Module 2 x 15cm Cable