We specialize in hard to find items
All Categories
Rockville DBM12 2000W Peak / 500w RMS 2 Ohm Marine/Boat Mono Amplifier Amp W/Covers+Bass Remote
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
Rockville DBM12 2000W Peak / 500w RMS 2 Ohm Features
-
Rockville dBM12 2000w Peak/500w Dyno-Certified RMS Class-D Mono 2-Ohm Marine Amplifier With Terminal Covers and Bass Remote.
-
Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, Rockford Fosgate, etc). 2 Ohm: 500 Watts x 1 Channel. 4 Ohm: 300 Watts x 1 Channel. Peak: (Use these ratings when comparing with the top budget brands such as Boss, Power Acoustik, etc). 2 Ohm: 2000 Watts x 1 Channel. 4 Ohm: 1200 Watts x 1 Channel. Fully Adjustable 12dB / Octave Crossover with Differential Circuitry.
-
Adjustable Low Pass Filter: 50Hz - 250Hz. Adjustable Subsonic Filter: 15Hz - 55Hz. Adjustable Input Level Control. Fully Adjustable 12dB Bass Equalizer. Minimum THD at Rated Power: <0.1%. S/N Ratio: >90 dB. Frequency Response: 15Hz - 250Hz. Damping Factor: >150 @ 100Hz. 60 Amp Maxi Fuse. Painted Conformal Coating PCB Board (Uses 2577 Waterproof Glue). Waterproof silicone covers for end panels. Rustproof Aluminum heatsink with white painted finish.
-
Stainless steel end panels are rustproof. All screws and mounting hardware are stainless steel and rustproof. Bottom panel is aluminum and rustproof. High-Speed MOSFET Power Supply. Optical Coupler Class"D" Technology. Phase Control Switch. Mute and Delay Soft Start System. RCA Preamp Line Output. RCA Input. 8 Volt Preamp Circuitry. Status Mode LED Indicator. Full IC-Controlled Protection Circuitry.
-
Remote Dashboard Subwoofer Control. Product Dimensions (W x H x L): 9? x 2.4? x 13.1? inches. Product Weight: 7.5 Lbs
About Rockville DBM12 2000W Peak / 500w RMS 2 Ohm
Description: The all new dB marine series of amplifiers gives you the best of both worlds! We took the sound of our best selling series of dB car amps and we added the best marine grade parts so that they will last forever and withstand even the harshest conditions on the water. We went a little overboard (no pun intended) to make this amp marine ready. We conformal coated the PCB board with a waterproof glue that is painted on to protect the circuitry. We then added waterproof silicone covers over the terminals so that water can never get into the amp. The heat sink, including the bottom plate, is made of aluminum which is rustproof. The end panels, all of the internal mounting screws and hardware of the amp are made of stainless steel and are rustproof as well. Even after many years of use the amp will be rust free and operate like new! The dBM12 is a mono amplifier with 2,000 watts peak output and 500 watts Dyno Certified RMS power. Here at Rockville we offer the best value in car audio. We therefore want to make it easy for you to compare our products to any brands on the market. The peak rating can be used to compare with brands who use peak ratings such as Boss and Power Acoustik while the Dyno Certified RMS rating can be used to compare with top brands such as Kicker, Rockford, Alpine, etc.
