SMARTGEN HAT600 Automatic transfer switch controller (ATS)

Pay with

SMARTGEN HAT600 Automatic transfer switch Features

• Low cost AMF controller designed to start/stop a generator automatically

• Suitable for 1-3 phase gasoline and diesel gensets

• Designed for front panel mounting

• Survives cranking dropouts

• Generator protection, built-in alarms and warnings

About SMARTGEN HAT600 Automatic Transfer Switch

Description:HAT600 series ATS controller is intelligent dual-supply module with programmable function, automatic measurement, LCD display, and digital communication. It combines digital intelligence and networking. Automatic measurement and control can reduce incorrect operation. It is an ideal option for ATS. HAT600 series ATS controller is made of microprocessor as its core, can accurately detect extended-spectrum 2-way-3-phase voltage and also make accurate judgment and output passive control switch under the abnormal voltage (over and under voltage, miss phase and over and under frequency). This controller has full consideration in various application of ATS (automatic transfer system) can be directly used for Intelligent ATS, Contactor ATS, Circuit Break ATS etc. It have compact structure, advanced circuits, simple wiring and high reliability, be widely used in electric power, telecommunications, petroleum, coal, metallurgy, railways, municipal administration, intelligent building, electrical devices, automatic control and testing system etc.PERFORMANCE AND CHARACTERISTICS1.System type can set for: Mains (1#) & Mains (2#), Mains (1#) & Generator (2#), Generator (1#) & Mains (2#), Generator (1#) & Generator (2#).2.Backlit 128x64 LCD, optional Chinese and English display, push-button operation.3.Measure and display 2-way 3 phase Voltage and Frequency:4.Measure and display active power, apparent power, power factor and 3 phase current;5.Over current alarm;6.Over/under voltage, loss of phase, reverse phase sequence, over/under frequency protection. 7.Automatic/Manual mode. In manual mode, can force switch to close or open;8.All parameters can be set on site. With Two different passwords which ensures authorized staff operation only. 9.During genset testing ATS controller can be set either on On-load or Off-load mode.10.ATS Controller has function of automatic Re-closing.11.Closing output signal can be set as on intervals or as continuous output.12.Applicable for AT