All Categories
AM Receiver module with external Antenna for 60kHz "Atomic Clock" Radio Signals like those available in USA and Canada, England and Japan; up to 2000 km Reception Radius depending on Weather and other Conditions; 1 bps Data Output with 3.3 or 5V Logic Level for Microcontroller
Reception Frequency 60kHz; Very High Sensitivity; Power Supply 2-15V; 1 bps Data Output for Decoding with Microcontroller like Arduino, Raspberry Pi, STM32, PIC and others.
Content: 1x PCB; 1x tuned Antenna 60kHz; 1x Crystal 60003Hz; 1x Male Header 10 Pin; Antenna, Crystal and Pins require Soldering
Content: 1x PCB; 1x tuned Antenna 60kHz; 1x Crystal 60003Hz; 1x Male Header 10 Pin; Antenna, Crystal and Pins require Soldering
For Downloads, Documentation and Product Support please visit UNIVERSAL-SOLDER Website.
The new version of UNIVERSAL-SOLDER / CANADUINO atomic clock receiver module is the most advanced and best equipped AM Atomic Clock Receiver module available today. We designed this product around the awesome receiver chip from Micro Analog Systems (Finland), just like the old module was. It means, this module is in particular designed for the use with micro controllers in an operating voltage range of 2 to 15V, and standard logic levels 3.3 / 5V. This is new: - We added an ultra quiet LDO voltage regulator, to offer a wide supply voltage range of up to 15V. - We added 4 LEDs to show the status of power, AGC, power down mode, and output. - We added drivers for the output signal, and an inverted output, both capable of driving up to 15mA. - We modified the antenna design for a better reception with an even shorter antenna stick. The new designed, fine tuned 60kHz antenna replaces the old 100mm long antenna, and guarantees even better reception than the old model. This module can be used to receive the atomic clock signal transmitted by: - WWVB (US/Canada) - JJY60 (Japan) - MSF (England). The advantages compared to other modules: - wide operating voltage range 2* to 15V - 60 mm tuned high-gain, high-Q antenna - super high sensitivity of 0.4V (RMS) - power down control pin - fast start-up - AGC control on/off This kit needs some soldering. Crystal, antenna, and pin header are not assembled for a more flexible use. So is it possible to use a different crystal and different antenna, for example for a 40kHz setup for Japan, or a DCF77 setup for Europe. If you dont want to develop your own project, you can find many projects online, using 60kHz atomic clock receiver. From Arduino data logger to Nixie tube clocks. There are also libraries for Arduino IDE and other development sources online.