MXBAOHENG PU Round Belt Welding Machine Drive Belt Connector Polyurethane Belt Hot Melt Machine Clamp+Scissor+Soldering Iron with Polytef Coating 110V/220V

Product ID : 47611193

---

  Share   Tweet

share more:

---

Galleon Product ID 47611193

Shipping Weight 4 lbs
I think this is wrong?

Model HJJ-003H

Manufacturer MXBAOHENG

Shipping Dimension 7 x 4 x 12 inches
I think this is wrong?

See more product information!

-

₱ 35,520

Price Tracker

+ ₱ 1,680
International Shipping

via AIR

This item ships longer than average delivery time. Click here to open chat and know how long it will take.

---

BUY NOW!

*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown

---

• Electrical items MAY be 110 volts.
• 7 Day Return Policy
• All products are genuine and original

Pay with

MXBAOHENG PU Round Belt Welding Machine Drive Belt Features

• PU Round Belt Welding Machine is a device that heats to a certain temperature and then maintains a constant temperature.

• The temperature of the connector is usually between 180 and 200 degrees.

• Using of bonding belts: V-belt, pentagonal belt, PU round belt, PU tube, plastic strip and others can be easily melted.

• This machine includes a connector and an electric soldering iron which are easy to operate and has a good stability.

• The bonded belt has a fast forming effect and the belt will not break.

About MXBAOHENG PU Round Belt Welding Machine Drive Belt

FeaturesRound belt Welding machine is a device that maintains a constant temperature by heating to a certain temperature. This device is easy to use and easy to operate, very stable effect is good, bonding belt forming effect fast, the belt will not break. Not hot, easy to use.The use of bonding belts are: V-belt, pentagonal belt, PU round belt, PU tube, plastic strips and other products can be easily melted.The temperature of the equipment is usually between 180 degrees and 200 degrees. How to use the adapter: 1 Fixed The belt to be connected is fixed in the groove (usually V, O-groove) below the aluminum fixture (the clamp main refers to the gasket and nut). Specifically, remove the nuts on both sides of the nut and nuts (depending on the diameter of the belt, if the belt can be inserted directly into the groove, do not remove the nut and gasket), the belt into the groove, the gasket and Nuts re-fixed in the groove above the sides of the plywood in a parallel state, the spacing is about 2cm or so is appropriate (can be placed in the middle of the thermostat heater)Tips: PU round with a small diameter of the polyurethane belt, please put the round belt on the top of the tank there, so that the round belt 2 connector alignment, then the larger diameter of the round belt or red polyurethane ribbons. Please put the bottom the inside of the groove!2 Heating. It will be heated to the constant temperature heater (the best temperature of the belt connection at 160-180 degrees), the fixed belt heating (the premise of the heat belt can not be bubbles, otherwise affect the connection effect), and then docking, the fixture Manual clamp nut tightened to the belt docking firm3 Re-processing. Belt docking to complete, to be completely cooled after the removal of the belt scraping, leveling.