5/8 x 24 Muzzle Brake Alignment Shims Kit .308 7.62 Indexing Stainless (18 Pieces)

Pay with

5/8 x 24 Muzzle Brake Alignment Shims Kit .308 7.62 Features

• Perfect Timing with Various Shims: Our kit includes different sized shims for precise muzzle device alignment. Each set contains 1 large shim, 4 medium shims, and 4 small shims, allowing you to fine-tune your timing with ease.

• Stainless Finish: The shims are completed with a robust stainless finish that provides both an attractive aesthetic and durability, ensuring your kit remains resistant to corrosion and wear over time.

• Compatibility: These shims are designed for barrels with a 5/8"-24 TPI, ensuring a wide range of compatibility with various firearms.

• Compact Design: With an outside diameter of just 0.85", our shims maintain a compact footprint, maintaining the sleek profile of your firearm without adding unnecessary bulk.

• Simplifies Installation: A superior alternative to traditional peel washers, our shim kit simplifies the process of mounting muzzle devices. There's no need for heating or peeling layers, just install the necessary combination of shims for precise alignment. This user-friendly design saves you time and effort during installation.

About 5/8 X 24 Muzzle Brake Alignment Shims Kit .308 7.62

Features: Different Shims for perfect timing Stainless Finish For barrels with 5/8"-24 TPI OD: 0.85" Muzzle Device Alignment Set Includes: 1x Large Shim 4x Medium Shims 4x Small Shim This shim kit is a replacement for the peel washer and is used for mounting muzzle devices. New muzzle brakes are normally supplied with the necessary washers, nuts, or shims; however, sometimes replacement washers are needed if one is damaged or if installing a muzzle device on a different gun. While Peel washers require you to heat them and then peel off separate layers of the washer to get to the desired thickness, a Shim Kit is much simpler. There is no heating or peeling of layers needed. Just install the necessary combination of shims to get the precise alignment you need. Each shim set ships with QTY 1 of Shim 1 (largest), QTY 4 of Shim 2 (Medium), and QTY 4 of Shim 3 (smallest). The large shim can be used to give the installer one half of a rotation or as a spacer for barrels that do not have relief cuts behind the threads. Shim 2 is used in varying quantities to achieve the proper alignment of your muzzle device. This shim gives the installer approximately 45 degrees of rotation. If needed, Shim 3 can be used where smaller degrees of rotation are needed for proper alignment.