11256 Throttle Body Spacer Compatible with GM Truck 4.8L, 5.3L, 6.2L 2007-2011 Replacement for Spectre Performance

Pay with

11256 Throttle Body Spacer Compatible with GM Truck Features

• Contains instructions and necessary gaskets and hardware for easier installation.

• Manufactured from the highest quality machined aluminum

• Improve engine performance and enhance your driving experience

• After the installation is completed, the vehicle needs to be shut down and re-checked to ensure that all bolts and hose clamps are fully tightened to ensure driving safety.

• Cold operation is required during operation to avoid burns

About 11256 Throttle Body Spacer Compatible With GM Truck

Parts List 1-Spectre Power Plate 1-1” Extension bracket 4-M6-1.0×70mm hex bolts 4-M6 flat washers 4-M6 lock washers 1-M6 flat screw 1-Gasket Installation Instructions Step 1 : Disconnect the negative battery cable. Step 2 : Remove the engine cover. Step 3 : Separate the upper radiator hose clip from the intake tube. Step 4 : Remove the two 10mm bolts & two 10mm nuts which secure the throttle body to the intake manifold. Step 5: Using a 4mm socket, remove the two studs that previously held the throttle body to the intake manifold. Step 6 : Using the supplied bolts, washers, and gaskets, install the Spectre Power Plate. Step 7 : The ball stud (from step 3)must be relocated. Step 8 : Reinstall the intake assembly by placing it over the throttle body, MAFS, and the ball stud. Step 9 : Fully tighten the clamps securing the intake assembly to the throttle body and MAFS. Step 10 : Install the C.A.R.B. exemption label near the factory emission label. Step 11 : Reconnect the negative battery cable. Step 12 : Start the engine and let the vehicle warm up. Shut the vehicle off and recheck your installation, making sure that all bolts and hose clamps are fully tightened.