Ignition Hall Effect Trigger Sensor,6-pin oval connector Compatible with BMW R-Series 12 11 7 673 277

Pay with

About Ignition Hall Effect Trigger Sensor,6-pin Oval

Part #: BOIgnSen-R277EDL (6-pin rectangular oval connector) EnDuraLast New Hall Effect Ignition Trigger sensor. Premium Quality aftermarket replica replacement part for the budget-minded repair. Compatible with BMW R850, R1100S 1998-04, R1150GS 1999-2004, R1150R 2001-04, R1200 1997-04 Make/Model: BMW : R1100S, R1150GS, R, RS, RT, R1200 Model Years: 1996 to 2006 Manufacturer #: 12 11 7 673 277 Manufactured in Germany (refer to "Extended Info" tab for more specific application information ) Note: Comes complete with correct 6-pin rectangular oval connector / plug-in harness connector. NEW - Not re-manufactured. The total swing in timing on the R850, R1100, and R1150 is 5°, the bike will start and run well at either end of the slotted hole. Important Installation Note: There is a two prong tab on the alternator pulley that engages with the groove on the crankshaft. This attachment should be bonded when torquing the pulley bolt to avoid damage to the hall effect ignition sensor. Verify that your rotor pulley is aligned correctly with the crankshaft before installing the hall effect sensor. If the install of the sensor is done with the rotor misaligned you could destroy the sensor, when attempting start it. Take care not to bend the locating tab on the rotor. Ensure the rotor is properly located back into the slot on the end of the crank shaft.