X
Holybro 500mW Telemetry Radio Set
Holybro 500mW Telemetry Radio Set
Holybro 500mW Telemetry Radio Set

Holybro 500mW Telemetry Radio Set (V3 for Pixhawk4) (915MHz)

Product ID : 41425487
4 out of 5 stars


Galleon Product ID 41425487
Shipping Weight 0.27 lbs
I think this is wrong?
Model
Manufacturer DevTu
Shipping Dimension 5.12 x 3.58 x 1.61 inches
I think this is wrong?
-
Product is Out of Stock as of Feb, 10 2024
Want to monitor availability?
of brand new stock?
or
Need this item ASAP?
Check if this is available on Amazon
or available in other sites
Send us the link so we can buy for you

Pay with

About Holybro 500mW Telemetry Radio Set

Holybro 500mW Telemetry Radio Set (V3 for Pixhawk4)915MHz Features: Transparent, full-duplex serial com-link Hardware flow control Open-source firmware Frequency Hopping Spread Spectrum (FHSS) Protocol Communicates with any 3DR/SiK telemetry radio Pixhawk not required — Easily adaptable to your other projects. Specifications: Radio Frequency: 915MHz Output Power: 20 levels, up to 500mW (27dBm) Size: 53x26x11mm (no antenna) Weight: 14g (no antenna) Rx Sensitivity: -117 dBm Operating range: -40 to 85°C Power Input: 5VDC (via micro-USB or JST-GH) Current, Tx: 500mA @ 27dBm Current, Rx: 25mA Serial (UART) Level: 3.3V Windows USB Device Driver: FT230X Chip Antenna Connector: RP-SMA Status LEDs: Green, blinking: searching for signal Green, steady: link established Red, blinking: transmitting Red, steady: firmware updating No Light: No Power Use Mission Planner, or any Terminal Emulator (AT/RT command set), to change available settings: output power, duty cycle, frequency range, number of channels, listen before Tx, error correction, opportunistic resend, link ID, air speed, MAVLink framing, etc. What’s in the box? 2x Radio Modules (interchangeable) 2x RP-SMA Monopole Antennas 2x 90° RP-SMA Antenna Connectors Micro-USB cable Android OTG cable JST-GH 6P to 6P cable for 2nd generation and later Pixhawk MLX 6P to JST-GH 6P cable for original Pixhawk 2x Adhesive pads