We specialize in hard to find items
All Categories
Pymeter Digital Temperature Controller Dual Probe Reptile Thermostat Controlled Outlet for Terrarium Heat Mat Heating Pad, Switch Cooling Fan Freezer Fridge ON & Off at Setpoints 10A 1200W
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
Pymeter Digital Temperature Controller Dual Probe Features
-
★★★★★ 「Think different, think simple」 You are able to set every outlet(attached to heater/fan) to turn on at a certain temp, and turn off at another temp.
-
★★★★★ 「2 controllers in one unit」Two outlets are individually separate, each supports heating & cooling. With two waterproof sensors, you can set different temps to control different areas, such as with 2 heat lamps/mats for 2 zones or even for 2 tanks.
-
★★★★★ 「Safe and Reliable」High and low temperature alarm, and temperature difference alarm, keep your target secure.
-
★★★★★ 「Convert freezer to refrigerator」With Power-On delay, it can protect compressor from frequent ON-OFF.
-
★★★★★ 「Widely used」It is used as temperature switches / thermostatically controlled outlet for heat mat / heat lamp / heating pad of reptile terrarium / tank, aquarium heater / chiller, greenhouse and grow tent heater, garage / attic exhaust fan, breeding, seedling and fermentation.
About Pymeter Digital Temperature Controller Dual Probe
Description 1. How Pymeter control temperature? Temperature controller is actual Heating/Cooling controller, thus MUST SET ON-Temp to turn ON Heating/Cooling, and MUST SET OFF-Temp to turn OFF Heating/Cooling. Heating starts at LOW Temp [ON-Temp(1oN, 2oN)], stops at HIGH Temp [OFF-Temp(1oF, 2oF)], thus for heating MUST SET 1oN(2oN) LESS than 1oF(2oF); In heating mode, 1oN(2oN) is the minimum temp you allow, 1oF(2oF) is the maximum temp you allow. Cooling starts at HIGH Temp [ON-Temp(1oN, 2oN)], stops at LOW Temp [OFF-Temp(1oF, 2oF)], thus for cooling MUST SET 1oN(2oN) GREATER than 1oF(2oF). In cooling mode, 1oN(2oN) is the maximum temp you allow, 1oF(2oF) is the minimum temp you allow. 2. Reading temp is inaccurate? Every Pymeter controller is calibrated before come out of factory, it is reading temp accurately! Please don't compare it to common inaccurate thermostat、thermometer or temp gun. If you doubt Pymeter controller accuracy, please calibrate with ice-water mixture (it is 32F when ice is melting), and you will see which device is accurate then. 3. Beeper keeps sounding? Probably it is the Alarm settings ( AL、AH、d7 ) you set are NOT the right temperature you want. AL is low temperature alarm(it sounds when current temp is AL or Lower), AH is high temperature alarm(it sounds when current temp is AH or Higher), d7 is difference alarm(it sounds when the temp deviation between sensor 1 and sensor 2 is over d7). If you don't need alarm function, please don't change the values of AL、AH、d7, the default values usually won't trigger alarm. You can factory reset by switching temp unit from F to C in setting. Please download User Manual PDF in Product information.
