We specialize in hard to find items
All Categories
ABN L5-50R Connector – 50 Amp Twist Lock Inlet, Locking Power Cord Connector, Locking Power Inlet Plug, 50A 125/250V
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
ABN L5-50R Connector – 50 Amp Twist Lock Features
-
CONNECT YOUR CABLE: Use your generator, transfer switch, welding equipment, trailer, RV camper power inlet with this ABN Inlet Locking Connector; Designed for use with round jacketed, hard usage cable (S-type); As long as you have a 3-prong male end with the same 50A 125/250VAC configuration, this connector will fit your application
-
KEEP OUT PESTS: Replace your power cord with this twist lock connector so the cord can be removed and stored without leaving an opening that mice or insects can enter and wreak havoc
-
SECURELY HOLD CABLE: This connector comes with strain reliefs that mount inside the base of the connector to hold the cable (clamp for the cord)
-
PERFECT SIZE: Approximate measurement across the face is 2 inches (5.1cm); Across the back where the cord enters adds 0.25 inch (2.25 inches / 5.7cm across); Total length is 5.1 inches (13cm)
-
EASY TO USE: Instructions included; Remove housing by loosening face screws and slide over cable (If a weather-resistant boot is used, slide this over the cable before the house); Strip cord outer jacket and each individual conductor to expose the copper wire; Insert all wires into proper color-coded terminal pockets; Tighten terminal screws and strain relief screws; Slide housing over connector body and tighten assembly screws (If weather-resistant boot is used, slide over complete assembly)
About ABN L5-50R Connector – 50 Amp Twist Lock
Replace the end on your existing power cord with the ABN Inlet Locking Connector. This female connector fits 3-prong 50A 125/250V male plugs or inlets and is designed for use with round jacketed, hard usage cable (S-type). Remove the housing by loosening the screws on the face of the device and slide it over the cable. If a weather-resistant boot is used, slide this over the cable before the house. Strip the outer jacket of the cord and each individual conductor. Insert all the wires into the proper color-coded terminal pockets. Tighten the terminal screws and the strain relief screws. Slide the housing over the connector body and tighten the assembly screws. If a weather-resistant boot is used, slide that over the complete assembly. WARNING: This product can expose you to chemicals which is [are] known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
