Streetside Tools SST-1001 - Shift Lever Seal Remover/Installer Transmission Tool

Product ID : 15901113

Product Rating

3.7 out of 5 stars

---

  Share   Tweet

share more:

---

Galleon Product ID 15901113

UPC / ISBN 645759000064

Shipping Weight 0.4 lbs
I think this is wrong?

Model SST-1001

Manufacturer Streetside Tools

Shipping Dimension 2.99 x 2.99 x 0.79 inches
I think this is wrong?

See more product information!

-

Save 37%

Before ₱ 3,515

₱ 2,229

Price Tracker

+ ₱ 210
International Shipping

via AIR

Get it between 2024-05-14 to 2024-05-21. Additional 3 business days for provincial shipping.

---

BUY NOW!

*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown

---

• Electrical items MAY be 110 volts.
• 7 Day Return Policy
• All products are genuine and original
• Cash On Delivery/Cash Upon Pickup Available

Pay with

Streetside Tools SST-1001 - Shift Lever Seal Features

• Made in the USA!

• Provides the easy removal and installation of the manual shaft (shift lever) seal.

• Draining of the transmission fluid is not required.

• The whole process takes just a few minutes.

• Similar to Atec Trans-Tool T-1001, Kent-Moore J-43909, J-43911, KD Tools 2393, Snap-On YA9348 and Schley SL96480.

About Streetside Tools SST-1001 - Shift Lever Seal

SST-1001 - Shift Lever Seal Remover / Installer Provides the easy removal and installation of the manual shaft (shift lever) seal. Draining of the transmission fluid is not required. The whole process takes just a few minutes. Similar to: Atec Trans-Tool T-1001, Kent-Moore J-26282, J-26401, KD Tools 2393, Snap-On YA9348 and Schley SL96480. For use on these Transmissions: 180,180C (3L30) (4L30-E) Short Shaft Only 200, 200C, 200-4R 250, 250-C, 350, 350C 325,325-4L 375,400 (3L80), 425, 475(3L80-HD) 700-R4 (4L60) (4L60-E Pre 1995 Short Shaft Only) POWERGLIDE Instructions: To remove the seal: 1. disconnect selector shaft linkage. 2. place remover over the shaft with the remover screw backed off. 3. Apply downward pressure by force or with light tapping with a hammer while screwing clockwise into the seal. once the remover threads are engage into the seal, remove the seal by turning the remover screw until seal is extracted. To replace the seal: 1. place the new seal on the selector shaft. 2. Place installer over end of selector shaft. 3. Apply downward pressure by tapping with a hammer. 4. Remove the installer. 5. Connect the selector shaft linkage. Note: This tool is intended for use on short shaft transmissions and will not work on long shafts. The SST-1001-PV is required for long shafts.