All Categories
🌵 Specification: Material: plastic Operating Humidity: 5%-95% Technical support: 2 AAA batteries. (Not included) 🌵 Technical Parameters: Supply voltage: 3V Maximum operating current: ≤22Ma Insulation strength: 50HZ, 500V sine wave test phone is applied between the input end of the power supply and the chassis for 1min without breakdown or flickering. 🌵 Instructions for use: 1. The main unit is hung or placed in a suitable position, and the control button is fixed with sponge glue or screws in the accessible position of the patient. 2. After the urine wet sensor board is connected with the host computer, it should be placed under the user's buttocks and covered with a dry towel or cloth. 3. When the patient presses the button or incontinence, the main unit will send out a music alarm sound. When the dry towel or cloth piece is replaced, the alarm sound will naturally stop. 🌵 Precautions: 1. Please use high-quality alkaline batteries, when the sound is significantly reduced when the battery should be replaced. 2. The internal electronic components of the product are precision electronic components; Users should not open it without authorization so as not to damage the internal structure. 3. Use the urine wet sensor board to cover the dry towel or cloth piece. 🌵 Packing List: 1* host 1* button 1* urine wet sensor board 1* instructions 🌵Note: Dear friend, if you have any question about the product, please contact us before leaving the feedback, we will deal with the issue immediately and carefully until you are satisfied.