Low Var Speed Auto CNC Electric winder Coil Winding wire Machine with foot pedal

Pay with

About Low Var Speed Auto CNC Electric Winder Coil Winding

The system consists of individual components including a controller, a stepper motor, a foot switch, power adapter and output shaft. . Technical data: Spindle speed: 10-700rpm Winding rotation accuracy: 0.9 degrees (0.0025 turns) The number of winding: groups Programmable winding turns: turns 0.1-6553.5 Winding direction: clockwise / counterclockwise Diameter range; 0.01-1.5mm Auto Start: Auto / Manual (0-1.5V level shifting) Cable way: by hand The amount of product count: 1-65535 Machine Input Power: 40W The maximum swing diameter: 80mm Power supply: AC110V/AC220V Host Size: 160mm (length) × 120mm (width) × 100mm (high) Ambient temperature: -20 degree - + 40 degree Instructions 1. the machine should be placed over a fixed working table, there are four fixing holes on the winding machine panel for mounting the winding machine and the table between the high speed because the machine can not have too much vibration phenomenon otherwise, long-term use may result in loose components welding point, line or unreasonable damage to electronic components, there will not show other symptoms. 2. the mold clamping should bobbin winding machine is mounted on a spindle, and tighten the mounting bolts, you should check whether the spool has a curved, bent, if you want to adjust or replace. 3. Winder initialization parameters, speed winding knob is reset back to zero, hold down the "+" and "-" simultaneously two keys, power winder, then winding machine controller parameters will be initialized. 4. run the machine should be preceded by pre-work state (spindle speed parameter C01 value) and the number of turns (C02 parameter values),  Press "SETUP" Setup and enter the spindle speed parameter C01 values ( "+" and "-" to change the parameter value);