FidgetFidget Dent Pit Repair Puller Removal Tool Car Body Paintless Glue Pulling Tabs Hammer

Pay with

About FidgetFidget Dent Pit Repair Puller Removal Tool

Instructions1.Clean the dent with a clean wet cloth;2.Mount the glue stick into the glue gun,pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes;3.Use a proper drawing gasket. Large dent requires a large drawing gasket. (Note: The larger the drawing gasket is, the larger the drawing force is);4. Pull the trigger and apply the drawing gasket with extruded glue (The 4 holes of gasket should be applied with hot melt glue);5. Fast place the drawing gasket with hot melt glue at the center of dent, press lightly until the glue cures and adheres (Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter);6. Align the T-shaped repairer and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent;7. Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen;8. Clean the repaired place with a clean wet cloth.Packing list:1 x 2 in 1 Dent Removel T Bar Tools18 x PDR Glue Pulling Tabs2x hot melt glue1x rubber hammer